798769
5
Zoom out
Zoom in
Previous page
1/8
Next page
6) Connect the Molex Connectors according to the color coding shown on the Digital
Control Wiring Diagram. You may have some excess length for the RTD Wires. This
additional wiring can be coiled and secured to the Digital Control Wiring with a cable
tie or a twist tie. Make sure that none of the wires interfere with the fan blades on the
Draft Inducer Fan or the Auger Drive Motor.
Replace the Grease Drain Pan and the Porcelain Grill, connect the Power Cord to an
appropriate, grounded electrical outlet and you are ready to go.
REPLACEMENT ON OLDER MODEL GRILLS
Some of the later model grills had a smaller cutout originally used for our controls.
These are the instruction for replacement for those models. After the original control has
been removed by following instructions and the RTD has been installed per instruction
above before you can begin.
1) Loosen the two screws on the green terminal block connector located on the
back upper right corner of the controller using a small screwdriver.
2) Insert the RTD wire out through the cutout for the control and connect to the
green connector located on the back of the new control into the green terminal
block and tighten down the screws.
3) Insert the wires for the control into the cutout. Then when inserting the control
into the cutout angle the control from the side away from the fuse and insert this
side first. You will need to slide the control all the way to the left at an angle until
the fuse holder clears the cutout.
4) Insert the two retaining screws into the holes provided on the face plate of the
control and tighten with a screw driver.
5) Connect the Molex connectors to the correct components per the wiring diagram
and then the grill is ready for use.
The small cutout is 2.25 remove fuse cap and fuse Install RTD wires to connector.
Insert wires and tilt controller Set controller flat and insert fuse from behind. Replace screws and connect wires.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Traeger BAC236 - Digitale Thermostat Kit at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Traeger BAC236 - Digitale Thermostat Kit in the language / languages: English as an attachment in your email.

The manual is 0.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info