Manual Toolcraft LDM 30 (page 36 of 85) (English, German, Dutch, French)

574412

Zoom out

Zoom in

1/85

g) Indirect Measurement

Use of the Pythagorean Theorem (a² + b² =

c²) permits, e.g., indirect determination of the

height of an object when there is no end point

for the laser to perform the measurement

(e.g. the upper end of a shelf).

Observe that the measurement „b“ is

performed at a right angle to the desired

height „c“.

Proceed as follows:

1. Keep the middle function button „ “ (C) pushed until a triangle appears at the top of the

display (indirect measurement). Release the button again.

2. Push the measuring button „ “ (B) briey to measure the rst side length (a). The measu-

red value is shown in the middle line (3). Then the lower dash of the triangle ashes in the

display.

3. Push the measuring button „ “ (B) briey to measure the second side length (b).

After the measurement, the middle line (3) shows the measured value of the second side

length, and the calculated height in m appears in the lower display line (4) (the right dash of

the triangle now ashes at the top of the display).

4. If another measurement is to be performed, briey push the measuring button „ “ (B). The

data are deleted from the display. Now continue with step 2.

Pushing the power button „ “ (D) several times will take you back to the previous

step or leave indirect measurement.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Toolcraft LDM 30 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,12 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Toolcraft LDM 30 Manual

Product: