574412

Toolcraft LDM 30 Manual

35
Zoom out
Zoom in
Previous page
1/85
Next page
35
f) Volume Measurement
The laser distance meter can determine the
volume of a space.
Observe that the area to be measured is
rectangular, since volume is calculated
by multiplying the three distances „a“, „b“
and „c“.
The measurements therefore must be made
at right angles to each other.
Proceed as follows:
1. Keep the middle function button „ “ (C) pushed until a cube appears at the top of the display
(volume measurement). Release the button again.
2. Push the measuring button „ “ (B) briey to measure the rst side length (a). The measured
value is shown in the middle line (3). Then the right lower dash of the cube ashes in the
display.
3. Push the measuring button „ “ (B) briey to measure the second side length (b). The
measured value is shown in the middle line (3). Then the middle dash of the cube ashes in
the display.
4. Push the measuring button „ “ (B) briey to measure the third side length (c).
After the measurement, the middle line (3) shows the measured value of the third side length,
and the calculated area in m³ appears in the lower display line (4) (the complete cube now
ashes at the top of the display).
5. If another volume measurement is to be performed, briey push the measuring button
„ “ (B). The data are deleted from the display. Now continue with step 2.
Pushing the power button „ “ (D) several times will take you back to the previous
step or leave volume measurement.
… 35 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toolcraft LDM 30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toolcraft LDM 30 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info