602805

Thule Xsporter Pro 500XT Manual

5
Zoom out
Zoom in
Previous page
1/14
Next page
5067034_03 5 of 12
4
• Slide Square Nuts at top of Saddle onto bottom Crossbar (J) t-slot. Make sure tapered side of crossbar is facing towards the truck cab.
Crossbar should remain loosely assembled for later adjustment.
Faites glisser les écrous à quatre pans situés sur le dessus de la selle dans la rainure au bas de la barre transversale (J). Assurez-vous que le côté
elé de la barre transversale est orienté vers la cabine de la camionnette. L’assemblage de la barre transversale doit être lâche pour permettre un
ajustement ultérieur.
En la parte superior de la montura, coloque las tuercas cuadradas deslizándolas por la ranura en “T” inferior del travesaño (J). Asegúrese
de que el lado más estrecho del travesaño esté dispuesto hacia la cabina de la camioneta. El travesaño debe quedar flojo para ajustarlo
más tarde.
• Repeat at other side of Crossbar, and follow same steps for second Crossbar and Base Assembly. See instructions p.1 for correct orientation
of Crossbars and Base Assemblies.
Répétez à l’autre extrémité de la barre transversale; ensuite, reprenez ces étapes pour la deuxième barre transversale et les assemblages des
bases. Consultez les instructions de la page 1 sur l’orientation des barres transversales et des assemblages des bases.
Repita este procedimiento del otro extremo del travesaño y realice los mismos pasos para el segundo travesaño y para el conjunto de base.
Consulte la página 1 de las instrucciones para conocer la orientación correcta de los travesaños y los conjuntos de base.
NOTE: Crossbars will be fully secured to Saddles once Crossbar / Upright assemblies are installed and adjusted on truck.
REMARQUE: Les barres transversales seront fixées solidement aux selles lorsque les assemblages de barres transversales et de montants seront
installés et ajustés sur la camionnette.
NOTA: Los travesaños deben ajustarse a las monturas por completo, después de haber colocado y ajustado el travesaño y las barras
verticales en la camioneta.
5
NOTE: XK3 adapter required for Toyota Tacoma (not included).
REMARQUE: Adaptateur XK3 requis pour ajustement sur Toyota Tacoma (non fourni).
NOTA: El vehículo Toyota Tacoma requiere el adaptador XK3 (no se incluye).
1. Thread 3" Button Head Cap Screws (K) loosely through front hole of Clamps (L).
Insérez sans serrer les vis d’assemblage à tête creuse de 3 po (K) dans les trous avant
des brides (L).
Ajuste los tornillos Allen de cabeza semiesférica (K) de 3 pulg. ligeramente a través
del orificio delantero de las mordazas (L).
2. Add T-Slides (N) to two of the Clamps by threading 3/4" Socket Head Cap Screws
(M) up through rear hole. Tighten fully using 5/16" Allen Key (O). Front slot on
T-Slide will index on 3" clamp bolt.
Ajoutez des fixations de rainure moulée (N) à deux des brides en insérant des vis
à tête creuse de 3/4 po (M) vers le haut dans les trous arrière. Serrez fermement
avec une clé Allen de 5/16 po (O). La rainure avant de la fixation de rainure moulée
s’alignera sur le boulon de 3 po de la bride.
Agregue las piezas fundidas con deslizamiento en “T” (N) en dos de las mordazas.
Para ello, ajuste los tornillos Allen de 3/4 pulg. (M) a través del orificio trasero.
Ajústelos por completo con la llave Allen de 5/16 pulg. (O). La ranura delantera
en la pieza con deslizamiento en “T” coincide con el perno de la mordaza de
7,6 cm (3 pulg.).
1 2
J
L
K
M
N
x 4
x 8
x 2
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thule Xsporter Pro 500XT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thule Xsporter Pro 500XT in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 3,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info