658790
8
Zoom out
Zoom in
Previous page
1/29
Next page
4
MENU Represents a button on the remote control or the receiver.
(Bold characters)
Move to Represents a menu item within a screen.
(Italic characters
1.4 Accessories
- 1x Installation instructions
- 1x remote control unit
- 2x batteries (AAA type)
- 1x adapter12 Volt DC, 1,5 Ampère
1.5 Usage of external USB devices
- It is recommended to use USB 2.0 or higher storage devices. If your device is not compatible to USB
2.0 specications, recording, Time shift and playback with your receiver might not work properly.
- If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be the case
that the power specications exceed the supported output of your receiver (5 V/1 A). If so, please
connect your USB HDD to an according external power adapter.
- STRONG cannot guarantee compatibility with all types of USB storage devices.
- It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver. STRONG
will not take responsibility for any loss of information or circumstances caused by loss of information.
- Please ensure that either the USB device is already formatted to FAT32, or format the USB device via
your receiver, refer to chapter 6.8 Recording.
- Playback of les cannot be guaranteed although extensions are listed, as it depends on codec, data
bit rate and resolution used (all MPEG codec formats are supported).
2.0 YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
Obr. 1a
1. q Switches the receiver ON or into Standby
2. P-/P+ Changes to the next/previous channel
3. Indicator LED GREEN indicates that the receiver is currently ON,
RED indicates that the receiver is currently in standby mode.
4. USB To connect your USB storage device
2.3 Side Panel
Obr. 1b
1. Smartcard slot To insert your valid and activated Irdeto smartcard for proper
reception of your desired channel bouquet. For the correct insertion
of smartcard please see the insertion drawing.
2.4 Rear Panel
Obr. 2
1. SAT IN To connect to the LNB of your satellite antenna for reception of
satellite broadcast signal
2. IR To connect the IR extender
3. S/PDIF (coax.) To connect to a digital amplier or home theatre set
4. HDMI To connect to the HDMI input of your TV set using a good quality
HDMI cable
5. TV SCART To connect to your TV set using a SCART cable
6. Power adapter To connect to the original included main power adapter
(Input 110 ~240V 50~60 Hz/ Output 12 V DC/ 1,5 A )
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Thomson THS815 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Thomson THS815 in the language / languages: English as an attachment in your email.

The manual is 1,03 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info