5 – DESCRIPTION OF THE CONTROLS
The appliance, when operating, could be hot to the touch, particularly the door of the combustion chamber: take care when handling
the appliance components. Your appliance has obtained the CE marking and has been made to run for at least one hour to check that
it functions correctly. The product must not be used by children, by persons with physical or mental impairments, by persons who
are not familiar with the instructions for use and maintenance of the product (the instructions are found in this use and maintenance
booklet).
CAUTION: Before each use make sure that the brazier is clean and positioned correctly in its lodging.
ATTENTION: the door must always remain shut tight when the appliance is operating. It is strictly forbidden to open the
door while the appliance is in operation. While the appliance is in operation the smoke exhaust pipes can reach
extremely high temperatures: do not touch them! It is strictly prohibited to use any type of fuel (liquid, solid...) other than
pallet to light up the appliance: lighting must occur automatically as intended and described in this installation, use and
maintenance booklet; consequently, it is also strictly forbidden to feed pellets (or any other material) into the brazier. Do
not place non-heat resistant or inflammable or combustible objects in the vicinity of the appliance: keep them at a
suitable distance. Do not place wet clothing to dry on the appliance. When using a clothes horse, keep at a suitable
distance. It is strictly prohibited to disconnect the appliance from the electrical power mains during normal operation.
5.1 DESCRIPTION OF THE CONTROL PANEL
The control panel is managed by a microprocessor. The control buttons and the various displays are described below.
The control buttons are:
Clock button
Press this button to activate / deactivate the programming.
Ventilation button
Press this button to set the desired level of ventilation: Ventilation can be turned off or set at six different levels. If
activated, it will start up as soon as the temperature inside the stove body rises, whereas it will stop automatically
when the stove body has cooled sufficiently.
Flame button
Pressing this button when the appliance is off activates the START sequence, sets the power of combustion in the
WORK mode or shuts off the appliance by activating the OFF sequence.
Scroll buttons (only in the Menu)
Press MINUS key to lower the value. Press PLUS key to raise the preset value.
Menu button
Press this button to access the main menu. You can scroll the setting screens shown below, which will be
described in detail in the following paragraphs. To access the functions of each subwindow wait a few seconds.
DATE/TIME This button is used to set the day of the week, the hour and minutes.
CHRONO This button is used to set the programmed on and off sequences.
LEVEL Is used to change the rotation speed of the smoke suction unit.
THERMOCOMFORT This button is used to activate the connection with the Room Control device (Optional).
SHOW CRONO This button is used to view the parameters programmed with the CRONO function.
