4.6 HANDLE AND DOOR OPENING
To open and close the door of the combustion chamber (C), open the outer door (A)
using the special handle (B) then disengage the latch using the same handle (B).
Open the door only for cleaning operations and exclusively with the appliance
cooled off and disconnected from electric power. Once you have completed this
operation be sure to remove the handle to avoid accidental opening of the door and
place it on the dedicated hook (D)
4.7 CONTROL PANEL
The front panel of the concealed control panel is installed on the right side of the appliance.
To open it, simply pull the panel outwards. To close it, push it in.
4.8 CONNECTING THE APPLIANCE TO THE FLUE OUTLET
Connection of the appliance to the flue outlet must be carried out in strict
compliance with the instructions contained in this use and maintenance
guide.
TOP SMOKE OUTLET
The appliance is designed with the smoke outlet at the top. Remove the cover (G)
and insert the exhaust pipe with its sealing gasket. Remove the pre-cut section with a
hammer or hacksaw then return the cover (G) to its original position.
This operation must be exclusively performed by qualified professional
staff, as set forth by Decree no. 37 of 22nd January 2008 and applicable
laws on the subject. Before performing said task, make sure the power
supply cable is disconnected from the electrical power socket.
REAR SMOKE OUTLET
If you choose to use the smoke outlet at the rear then loosen the two screws (E)
and remove the side panel (F) by lifting it upwards. Unscrew the knobs (A) and
remove the bracket (B). Undo the screws on the collar (C) and the flange (D)
and remove both elements. Next interchange the positions of the collar (C) and
the flange (D), secure them and ensure that the seals are perfectly tight.
Remove the cover with pre-drilled hole from the bracket (B) and return the
bracket (B) and the side panel (F) to their original positions.
This operation must be exclusively performed by qualified professional
staff, as set forth by Decree no. 37 of 22nd January 2008 and
applicable laws on the subject. Before performing said task, make sure
the power supply cable is disconnected from the electrical power
socket.
