Manual Texas Rider 6100E (page 13 of 23) (English, German, Danish)

636645

Zoom out

Zoom in

1/23

Operation

Always check and refill oil before the start!

The oil level should always be between min. and max

on the dipstick. Fill with SAE-30 oil follow instrucktion I

engine manual. Use only unleaded 95 octane fuel to the

engine. Never overfill the tank.

Cutting height adjustment: Illustration 3-3

(The illustrations may vary from your actual model)

The mower has 5 different heights. The cutting height

ranges from 35 mm to 75 mm

Start

Never start the mower directly on long grass.

Electrical starter, illustration 3

1. By cold engine set the choke lever on ”Choke”-

By warm engine set the choke lever on ”Run”

2. Move the gear lever to postion N

3. Regulate the height adjustment from 1 to 5.

4. Press the foot pedal fully.Turn the engine key

to start(on) and return the choke lever in

the”run” position. (only cold engine).

Set speed lever in gear from 1 to 4 (R)

5. Release the hand brake

6. Activate the blades and release the foot pedal.

Recoil with choke, speed lever

1. By cold engine set the choke lever on ”Choke”-

By warm engine set the choke lever on ”Run”

2. Move the gear lever to postion N

3. Regulate the height adjustment from 1 to 5.

Press the foot pedal fully.Turn the engine key

to start(on). Pull the recoil starter gently until

you feel resistance in the rope, then pull

quickly and energetic. Do not at any time let go

of the recoil starter but slide it gently into

starting position and return the choke lever in

the”run” position (only cold engine).

Set speed lever in gear from 1 to 4 (R)

4. Release the hand brake

5. Activate the blades and release the foot pedal.

Regulation of speed

Speed can be adjusted from 1.5 – 4.6 km/h while

driving. Activate the right handle on the dashboard and

set in one of the 4 different speeds or reverse. When

driving in one the two lowest speeds the pace

difference will not vary significantly.

Stop: Illustration 3-6

1. Turn the ignition key to the off position.

Note: The blades will still rotate at up to 3 seconds

after stopping.

Water nozzle

The left side of the mower deck is fitted with a water

nozzle for washing the deck. See Illustration 1-D

 Attach a hose to the nozzle.

 Turn on the water and start the engine.

 Activater the blades. The rotations of the

blades will ensure that the water will clean the

underside of the deck.

Note: For best result clean the deck with the water

nozzle function right after each mowing. If the grass

dries out, this function will not work optimally.

Blade

Inspection of the blade

 Inspect blade for damage, cracks or excessive

rust or corrosion.

 Check that the blade bolt is tightened.

Note: A dull blade can be sharpened! But a blade that

is worn, bent, cracked or otherwise damaged must be

replaced.

Mounting the blade

If you remove the blade to sharpen or replace it, you

must use the correct tool and some heavy gloves to

protect your hands.

1. Loosen the blade bolt. Use a piece of wood to

prevent the blade from turning around.

2. Remove the bolt, washer, blade and blade

holder in that order

3. Sharpen or replace the blade.

4. Insert the blade holder, blade, washer and bolt

in that order.

5. Tighten the blade bolt. Use a piece of wood to

prevent the blade from turning around.

Warning: A blade must be sharpened so it is in

100 % balance, otherwise it may cause vibrations that

could damage the engine. Damage to engine due to

faulty sharpening is not covered by warranty. We

therefore recommend letting a service center sharpen

the blade.

Spark plug

1. Remove the spark plug.

2. Brush off dirt from the spark plug.

3. Use a spark plug wrench to loosen the spark

plug.

4. Check the insulation is intact.

5. Clean the spark plug with a wire brush.

6. Measure the electrode, taking care not to

damage the electrode.

7. The distance should be: 0.7 to 0.8 mm

8. If the spark plug is undamaged refit or replace.

9. Reattach the spark plug.

My Texas rider 6100e will not start. The motor spins on operation but will not fire up Submitted on 22-3-2018 at 15:48
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Texas Rider 6100E in the language / languages: English, German, Danish as an attachment in your email.

The manual is 1,54 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Texas Rider 6100E Manual

Product: