Manual Telair Energy 2510b (page 21 of 40) (English)

688849

21

Zoom out

Zoom in

Previous page

1/40

Next page

Vers. 002

Energy 2510 B

GB

21

the electronic control panel will turn off the gen-

erating set.

To select automatic or

manual mode is necessary to position the

AUTO / MAN switch before turning on the

panel with the ON / OFF switch.

Remember that the time which is taken by the

generating set in automatic mode to recharge the

battery may vary according to the battery status,

the amount of connected batteries and the ambi-

ent temperature.

Generally, the lower the temperature the less the

time required to charge the battery.

Applying any load higher

than the energy just then available in the bat-

tery will prevent the generating set from turn-

ing on due to insufficient voltage.

7 MAINTENANCE INSTRUCTIONS

Only use original spare

parts. Using poorer quality spare parts may

damage your generating set.

Routine checks and adjustments are of the

essence in preserving a high level of per-

formance. Routine maintenance also ensures

long generating set life.

Before performing any

check or maintenance operation on the gen-

erating set, turn the selector switch (Fig. 31

Ref.2) to the position 1 “manual” in order to

avoid accidentally starting up the generating

set.

7.1 Service check list

See table at the bottom of page 24.

7.2 Maintenance not requiring specialised

personnel

To perform this kind of service, it will be neces-

sary to open the generating set door. The follow-

ing precautions must therefore be taken:

1 The generating set must not be in operation,

and all its parts must be cold

2 Turn the selector switch to the position "ON"

(manual) (Fig.31 Ref.2)

N.B. Remember to switch the selector switch

to "OFF" (automatic) after completing the re-

quired checks.

7.3 Checking the engine oil level

All engine oil level check-

ing operations must be performed with the

generating set in a perfectly horizontal posi-

tion.

•

Unscrew the engine oil filler cap and clean the

dipstick (Fig.33 Ref.1).

•

Put the dipstick back in without screwing.

•

Take the dipstick out again, and make sure

that the engine oil level is between the two

(min and max) notches. Should the oil level be

below the minimum notch, restore the oil level

using the recommended type of engine oil (re-

fer to the engine user and maintenance man-

ual).

•

Put the dipstick and filler cap back on and

screw tightly.

Do not fill to exceed the

maximum level, as this could cause malfunc-

tioning of the fuel pump and hence of the

generating set.

1

Hello,
I can not get start on my Telair Energy 2510b. It seems to me that the fuel do not reach the "engine".
Fuel pump?

Det ser ikke ut som bensinen suges fra bensintanken. Kan dette være årsaken og evnt.hva må gjøres?
Jeg tatt service, skiftet olje, skiftet tennplugg og rengjort luftfilter.

mvh
Thor, +4795972210
thor@jemtland.no

Submitted on 8-7-2022 at 08:48
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

Register

Register getting emails for Telair Energy 2510b at:

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Telair Energy 2510b in the language / languages: English as an attachment in your email.

The manual is 4,66 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info