801425

Techno line WS9008 Manual

12
Zoom out
Zoom in
Previous page
1/75
Next page
EN2
1
2
3
4
5
6
7
Wireless 3-in1-Sensor
1 - Wind cup
2 - Radiation shield
3 - Battery compartment
4 - Bottom case
5 - Mounting clamps for bottom case
6 - LED indicator
Flashes when the remote unit is transmitting
7 - [ RESET ] key
Setup & installation
Install wireless wind speed 3-in-1 sensor
Note:
After replacing the batteries of the wireless sensor or the unit fails to receive
wireless sensor signal of a specified channel, you need to press and hold [
SCAN ] key on the console to pair this sensor again.
*The building material and the position of the receiver and transmitter affect the
effective range. So try various locations to obtain the best result.
Place the units away from metal objects and electrical appliances to minimize the
interference.
Power up the station
1. Remove the battery door and insert 2 x AA batteries into the battery
compartment, according to the polarity mark on the battery compartment.
2. Once the batteries are installed, all LCD segment will be shown.
3. Replace the battery door.
1. Turn the top case anti-clockwise to
open.
2. Remove the battery door.
3. Insert 3x AA size batteries into the
battery compartment, then close the
battery door.
Note:
Make sure you insert the batteries in right
way according to the polarity information
marked on the battery compartment. Once
installed, the LED indicator flashes and
start transmit the signals.
4. Twist the Top case clockwise.
5. Mount the 3-in-1 sensor on a pole by
using the clamps with the big screws and
nuts
Note:
The possible pole diameter is between
28 ~ 40mm.
Mounting guidelines
- Secure the clamps (included) to a post or pole.
- Install the sensor at least 1.5m off the ground for better and more accurate wind
measurements.
- Choose an open area within 150 meters* from the LCD display console.
Step 1
Step 2
Step 3
Step 4
Step 5
Not
included
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Techno line WS9008 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Techno line WS9008 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 3.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info