8.5.3 Updating Software
You also have the facility of updating the operating software of your digital receiver.
> Press OK to display the sub-menu Software update.
To perform a software update, mark the line Software update.
> Set the software update function to on by pressing OK.
> In the line Update time, use the numeric keys to set the time when the software
update is to be carried out.
> To initiate the update for the operating software manually, press the redfunction key
Test.
> Press the Menu key to return to normal operation.
Should the parameters of the data used to download the soft ware update have changed,
you can correct these via the menu. Current transmission data can be obtained via your
retailer. Under normal cicumstances, there should be no need for you to make any changes
in this menu.
Note:
For the new software version to be downloaded automatically, the digital
receiver must be in standby mode. The downloading procedure is indica-
ted by “TErL”, followed by “TEr0” to “TEr9” in the display. Ensure that this
procedure is not interrupted by switching the receiver on or off while the
download is in progress.
Independent of whether you have switched the automatic software update function on or off,
the receiver will check automatically each time it is switched on whether a new version of the
operating software for your digital receiver is available. If a new version of the operating soft-
ware is available, this will be indicated by a message displayed on screen.
To start the software update, follow the instructions displayed on your screen.
8.5.4 Copying settings
You have the facility to copy all the settings of the programme list, antenna settings, etc. of
your digital receiver from your receiver to another digital receiver of the same type, and using
the same operating software version.
> Use a null modem cable to connect the two receivers.
> Switch on the receiver to which the settings are to be transferred.
> To copy the settings, press one of the keys on the panel of the source receiver.
The settings of this source receiver will now be transferred to the other, receiving,
receiver. Please note any messages displayed on screen.
8.6 System configuration
Use this menu item to view the specific data relating to your receiver.
> Use the arrow keys up/down to mark this line in the sub-menu Settings.
> Confirm by pressing OK.
> Press the Menu key to return to normal operation.
8.7 Encryption/decoding system
This menu point takes you to the sub-menues for the CONAX Smartcard used, and for the
CI module. You can view information related to the Smartcard or the CI module used by
36
