487285

Team SIS 9 Manual

12
Zoom out
Zoom in
Previous page
1/40
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don‟t change
the page numbering. Keep the language integrity.
12 TEAM SIS 9 - 071121
Assembly page 12/40
Fax +32 2 359 95 50
The iron heats up quicker than it cools down. Therefore, start ironing the articles requiring
the lowest temperature such as those make of synthetic fibres. Then progress to the higher
temperatures.
If the article is made of a mixture of different fibre, you must always select the lowest
ironing temperature of the composition of those fibres. (E.g. an article consisting of “60%
polyester and 40% cotton” should be ironed at the temperature indicated for polyester
and without steam).
If you do not know what kind(s) of fabric(s) the article has been made of, find a spot,
which will be invisible when wearing or using the article to try out the ironing temperature.
(Always start at a low temperature and increase to one, which gives the required results).
Pure woollen fabrics (100% wool) may be pressed with the iron set to a steam position. It is
recommended to apply shot-of-steam and use a dry pressing cloth.
When steam-ironing woollen fabrics, shining of the fabric may occur. This can be
prevented by turning the article inside out and ironing the inside or by interposing a light
damp cloth.
Velvet and other textures that rapidly acquire shiny spots should be ironed in one direction
only (with the nap), applying only light pressure.
Always keep the iron moving.
Iron the reverse side of synthetic materials and silk, it is not advisable to use steam as this
may cause stains.
FILLING WITH WATER (FOR STEAM-IRONING)
Make sure the main plug is unplugged from the wall socket.
Put the switch of the water tank (1) in off position ("0").
Position the base of the appliance on a stable flat surface and unscrew the cap (if you left
water in the tank and the cap screwed, a light degazing will happen during the next use.
It‟s normal and presents no danger).
Fill the steam tank with water (max. 0.75 litre).
You can use tap water, however, if the water is very hard, it is advisable to use distilled
water.
Never use vinegar, descaling agents or other chemicals.
Close the steam tank by turning the screw cap clockwise by hand (see page 5).
WHILE IRONING
CAUTION : WHEN THE APPLIANCE IS IN OPERATION, THE STEAM TANK WILL BE UNDER PRESSURE
WITH HOT STEAM.
FIRST OF ALL BE SURE THAT THERE IS NO MORE STEAM IN THE WATER TANK. THE BASE AND THE
IRON ARE ALWAYS UNDER PRESSURE, BLEED THE TANK BY PUSHING THE BUTTON (8) UNTIL NO
MORE STEAM ESCAPES, THEN SWITCH OFF THE BASE AND THE IRON (SWITCH (1) IN OFF-POSITION
("0), THERMOSTAT IN "MIN" POSITION) AND UNPLUG THE APPLIANCE. CAREFULLY UNSCREW THE
CAP IN ORDER TO CHECK IF THERE IS NO MORE STEAM AND THEN UNSCREW IT COMPLETELY. LET
THE TANK A FEW MINUTES COOL DOWN AND THE FILL IT AGAIN. ATTENTION: IF YOU FILL TOO
EARLY, STEAM OR HOT WATER WILL ESCAPE FROM THE OPENING. WE ADVISE YOU TO PROCEED
SLOWLY WHEN YOU FILL IN EVEN AT THE BEGINNING. FINALLY CLOSE THE WATER TANK WITH THE
CAP. YOUR APPLIANCE IS READY TO OPERATE.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team SIS 9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team SIS 9 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Team SIS 9

Team SIS 9 Additional guide - English, German, Dutch, French, Italian, Portuguese, Spanish - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info