487285

Team SIS 9 Manual

11
Zoom out
Zoom in
Previous page
1/40
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don‟t change
the page numbering. Keep the language integrity.
11 TEAM SIS 9 - 071121
Assembly page 11/40
Fax +32 2 359 95 50
NEVER UNSCREW THE CAP OF THE STEAM TANK WHILE THE APPLIANCE IS CONNECTED TO THE
MAINS WALL SOCKET AND ESPECIALLY WHEN STEAM IS BEING PRODUCED.
Always place the iron on the base of the appliance, on the therefore foreseen place. Do
not place iron by its rear cover. Be sure that it doesn‟t come in contact with flammable
materials or with the mains cord.
Never fill the steam tank with vinegar, descaling agents or other chemicals.
Before using for the first time remove any sticker or protective foil from the soleplate. Clean
the soleplate with a soft cloth.
Some parts of the iron have been slightly greased and as a result the iron might slightly
smoke when switched on for the first time. After a short while, however, this will cease.
The iron shall be used and placed on a stable level surface.
Do not use the iron if it has fallen, if it shows any visible signs of damage or if it leaks.
When you place the iron on its support (if available with the model), make sure that the
surface on which you put it is stable.
(*)
Competent qualified service: after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this service.
STEAM IRON: USE PRECAUTION AND TEMPERATURES
Always check first if a label with ironing instructions is attached to the article to be ironed.
Follow these ironing instructions in all cases.
If ironing instructions are missing but you know the kind of fabric, then see the table for
recommended ironing temperatures.
As soon as you plug in the appliance, the iron is switched on, even if you haven't
activated the water tank's switch. Turn the thermostat (4) to the desired position. The pilot
light (6) of the iron will come on. As soon as the desired temperature is reached, the pilot
light (6) goes out.
During ironing this pilot light will come on from time to time. When this happens, the
soleplate is being heated-up to the required temperature again. You can continue
ironing.
The table is valid for the fibre materials only. If some kind of finish has been applied (gloss,
wrinkle, relief etc), the textile can best be ironed at a lower temperature. First sort out the
fabrics according to ironing temperature: wool with wool, cotton with cotton, etc.
Kind of textile
Synthetic (e.g. acetate,
acrylic, viscose,
Polyamide, polyester, ….)
Silk
Wool
Cotton
Linen
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team SIS 9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team SIS 9 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Team SIS 9

Team SIS 9 Additional guide - English, German, Dutch, French, Italian, Portuguese, Spanish - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info