487279

Team SIS 3 Manual

16
Zoom out
Zoom in
Previous page
1/48
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don‟t change
the page numbering. Keep the language integrity.
16
Assembly page 16/48
Fax +32 2 359 95 50
AUTO SHUT OFF FUNCTION
1. When the pilot light of the base (6) switches from off to blinking (= initial mode) and then
to on (= working mode), the 15-minute auto shut off function is activated.
2. In working mode, if you do not press the steam button within 15 minutes, the appliance will
be switched off. Only the power light (5) will stay on.
3. In working mode, if you have pressed the steam button within these 15 minutes, the auto
shut off function will only start the countdown after the last time you pressed the steam
button.
4. If you press the reset button after the countdown has started but before the 15 minutes
have elapsed, the appliance will switch off and only the power light (5) will stay on. The
appliance will be in standby mode, no other function will be active. If you want to
continue to use the appliance, press the reset button (8) and the base will switch to its
initial mode or working mode (according to the parameters explained under steps 5 and
6 below).
5. If the appliance has been switched of for a period longer than 10 minutes and 10
seconds, pressing the reset button will switch the appliance on in initial mode.
6. If the appliance has been switched of for a period shorter than 10 minutes and 10
seconds, pressing the reset button will switch the appliance on in working mode.
7. In working mode, when the auto shut off function has been activated, you will hear a
beep 30 seconds before the 15 minutes are elapsed. After these 30 seconds the power
light will start blinking, indicating that the auto shut off function is still active. If you want to
continue ironing, press the reset button once. If you want to stop using the appliance,
press the reset button twice. Only the power light will be on, you can unplug the
appliance.
WHEN FINISHED IRONING
Unplug the appliance and let it cool down.
It is not necessary to empty the water tank.
We recommend placing the iron on its base when you store it. The therefore foreseen
place is non-slip and will not damage the soleplate of the iron.
ANTI-SCALE CARTRIDGE
Your appliance is equipped with an anti-scale cartridge (13) situated underneath the
water tank. As a result, you can use tap water as it will be filtered by the cartridge.
It is necessary to replace the cartridge approximately every 6 months. However this period
may vary depending on the frequency of use and of the scale content of the water in
your area. If the water contains much scale, you will have to replace the cartridge more
frequently.
To take it out, press the pins situated at both ends of the cartridge and raise the latter.
To buy a new cartridge, please contact the nearest customer service.
Never use the appliances without anti-scale cartridge!
CLEANING
The plastic parts of the appliance can be cleaned with a damp cloth.
To clean the soleplate of the iron, you will find specific products in the shops. Please also
read the instructions of use. Never use abrasive products to clean it.
Never immerse the appliance in water or any other liquid.
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team SIS 3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team SIS 3 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info