486877

Team EXP 11 C Manual

8
Zoom out
Zoom in
Previous page
1/20
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don‟t change the page numbering. Keep the
language integrity.
8 EXP 11 C - 070612
Assembly page 8/20
Fax +32 2 359 95 50
7. To check or to modify the programming time, press the PROG button twice and it will be
displayed. You can now modify as you like.
8. When your appliance will start at the programmed time, the yellow pilot light (I) will go out
and the red pilot light (A) will come on, indicating that the brewing process has started.
9. The hot plate allows keeping the coffee hot for about 2 hours but after this delay, your
appliance will automatically cut out.
10. You can switch off your appliance anytime simply by pressing twice the 0/I switch (C).
HOW TO PREPARE AN ESPRESSO
Espresso is a strong coffee, with a characteristic taste, extremely rich in aroma. Therefore, the
water, which arrives in the filter with a high temperature, is pushed very fast through the coffee
mass by a strong pressure. It extracts the nectar from the grinding and draws the essential
aromas from the coffee. That‟s why the espresso is usually served in small “espresso” cups.
Use preferably a special espresso coffee with suitable roasting and grinding.
Remember that the espresso needs a finer grinding than the standard coffee.
1. Insert the plug in the power supply.
2. Insert the espresso filter (11) into the espresso filter holder (9) (Fig.1). Fill the filter with the
desired quantity of ground espresso coffee (Fig. 2).
3. Gently tamp the coffee into coffee filter and remove the excess coffee from the edge of
filter holder (9). This will ensure the good positioning of the filter holder in its support.
4. Do not tamp to hard. To avoid a blocking or an overflow, do not overfill the filter.
5. Caution: Check that the filter locking flap is as far as possible from the filter. Position the
filter holder (9) in the support of the filter holder. Turn firmly to the right until it blocks (Fig. 3).
The filter holder (9) should be the most on the right as possible, as close as possible to the
symbol located on the filter holder support. If the filter holder (9) does not fit in the
closing zone and at least in the middle of the appliance, do not operate your appliance,
remove the filter holder (9) and position it again as described here above until the filter
holder is in the closing zone. This will avoid that the filter holder (9) comes out of its housing
as the pressure rises when the coffee is flowing through the filter.
6. Lift the cap of the tank (1).
7. Fill the water tank with cold tap water (Fig. 4).
8. Close the water tank with the cap (1).
9. Then place the lid on the espresso jug (10) in such a way that the opening of the jug lid
faces the spout of the filter holder (9) (Fig. 5).
10. Place the jug underneath the filter holder (9). Check if the spout of the filter holder faces
the opening of the jug lid (Fig. 6).
11. Caution: Make sure that the grid of the drip tray (6) is placed.
12. You can also put a cup directly underneath the filter holder. In that case, we recommend
you put the cups on the warming plate (2) to preheat them.
13. You are now ready to prepare espressos. Press the espresso On/Off switch , the
orange and green pilot light will come on. After 3 minutes, the orange preheating pilot
light (f) will go out, then turn the function selector to the position.
14. After about a few seconds, the coffee will start flowing.
15. Once the cup is full, press espresso On/Off switch . The green pilot light will go out.
Do not forget to turn the function selector to “0” position.
16. Before removing the filter holder (9), make sure there is no more pressure in the tank (as
described in the section SAFEGUARDS CONCERNING STEAM UNDER PRESSURE).
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Team EXP 11 C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Team EXP 11 C in the language / languages: English, French as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info