617907
16
Zoom out
Zoom in
Previous page
1/132
Next page
16 TASCAM HS-2
When REMOTE Select (pin 14) is set to high, it can be used
as an ordinary parallel controller. When set to low, flash
start mode is enabled. In addition, depending on the
high/low setting of the Flash Page (pin 20), the key assign-
ments are as follows.
Pin 14 Pin 20 Flash start take
Low High 1–10
Low Low 11–20
The following example is of a connection that uses a fader
to start and stop playback of this device.
For information about the assignment of AUX 1–3 (pins
17–19) functions, see “PARALLEL page” on page 96.
NOTE
When controlling this unit with an external device that is
connected to the PARALLEL connector, by simultaneously
asserting the PLAY and RECORD signals while this unit is
stopped, you can start recording immediately. In addition,
by simultaneously asserting the PLAY and RECORD signals
during playback in timeline mode, you can start
overwriting the recording.
RS-232C connector
The RS -232C connector on the rear panel can be
connected to an RS-232C connector on a computer to
allow control of this unit from that computer.
Make settings related to communication on the
RS232C
page of the
REMOTE SETUP
screen. (See “RS–232C page”
on page 96.)
NOTE
Please contact TASCAM customer support for information
about this unit’s RS-232C command protocol.
RS-422 connector (Attached to Option SY-2
Board)
The Option SY-2 Board is equipped with the RS-422
connector.
You can control this unit remotely by installing the SY-2
Board to this unit and connecting the RS-422 connector
on its rear panel to a controller or editor compatible with
the SONY P2 protocol (RS-422).
Make settings related to operation on the
REMOTE SETUP
screen
RS422
page. (See “RS–422 page” on page 96.)
NOTE
Please contact TASCAM customer support for information
about this unit’s protocol compatibility.
2−Names and functions of parts
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tascam HS-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tascam HS-2 in the language / languages: English as an attachment in your email.

The manual is 4,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info