20
How to Use
21
How to Use
10
Display of results
The trunk fat % percentage and Visceral fat rating are
displayed on the upper and lower bar, respectively.
* The main unit buzzer will sound twice when the results have
been displayed (beep, beep).
* Refer to pages 32 and 33 for how to read results.
11
Storing the impedance meter
Always store the impedance meter in the main unit upon completion of measuring (the
impedance meter transfer mode will end and the meter will return to a state ready for use).
12
For Your Reference
Take care not to catch the body hair or skin of the
subject when moving the impedance meter on the
abdomen. Use both hands on either side of the
impedance meter, as shown in the diagram.
Please…
Pillows can cause errors in
measurements. Avoid using as
much as possible.
1.Slide the impedance
meter down from
the top.
2.Hang the switch
hanger on the main
unit hook
Press the key on the main unit to turn
on.
The initial screen is displayed.
This mode allows measurements to be easily taken
when the waist of subject is too big to be
accommodated by the main unit.
Place the main unit close to the supine subject as
shown in the diagram below.
*The main unit will switch off
automatically after two minutes in the
absence of any operation.
1
Press the key to change the
mode.
* At right is the screen when the [over 130cm] mode is
selected.
2
*Blue print in display illustrations indicates parts that illuminate or flash.
For Your Reference
Please use the tip of a pen or other fine
instrument to press the key (taking
care not to damage the unit).
Check that the Power
LED is off
Suitably firm surface
(thin mat, examination table, etc.)
Measuring
standard mode (cont’d)
Measuring
waist circumferences over 130cm
End measuring
Press the key on the main unit to turn off.
* If the main unit power is not turned off, it will automatically turn off after results have been
displayed for approximately two minutes.
