687778

Switel BCF268 Manual

43
Zoom out
Zoom in
Previous page
1/50
Next page
Putting the Units into Operation
43
Connecting the receiver
Attention: Position the receiver with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance.
Operating with a power adapter plug
Ensure you use the correct power adapter plug. The receiver must be connected by means
of the larger power adapter plug which has an output power of 500 mA.
Connect the cylindrical plug on the power adapter plug cable to the receiver’s power supply socket
(9 V DC).
Connect the power adapter plug to a power outlet (230 V).
Operation with batteries or rechargeable batteries
Open the battery compartment on the rear side of the receiver. Loosen and remove the screw and
slide the battery compartment cover downwards.
Insert the battery pack or batteries paying attention to correct polarity. Refer to the diagrams in the bat-
tery compartment.
The receiver unit can be operated using 5 normal AA" batteries or rechargeable batteries of
the same type. Please remember that standard rechargeable batteries cannot be recharged
directly in the receiver. A commercially available charging unit is required to recharge bat-
teries.
Only special batteries can be recharged directly in the receiver. They are contained in the ma-
terial supplied. If you have any further queries, please contact your sales outlet.
Close the battery compartment, reinsert and retighten the screw.
The Power LED turns orange when the battery charge is too low.
Attaching the belt clip / wall mounting bracket
Slide the belt clip downwards on the back of the receiver until it audibly snaps into place. To remove it,
release the fit by pulling the belt clip out of the catch and sliding it upwards.
Wall installation
The belt clip is provided with a hole used for installing the unit on a wall.
Be careful not to drill into electrical lines or water pipes! Ensure that no lines or pipes are under
the required installation location!
Dowels and screws are not contained in the material supplied.
Drill a hole (diameter 5 mm) at the required position in the wall.
Insert a dowel (5 mm diameter) in the hole.
Insert a screw (4 mm diameter) in the dowel.
Leave approx. 3 mm from the head of the screw to the wall.
Guide the recess in the receiver over the screw head and pull the unit down gently.
… 43 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Switel BCF268 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Switel BCF268 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 0,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info