664347
7
Zoom out
Zoom in
Previous page
1/11
Next page
7
1. After power On, water tank indicator light will light up for easy viewing of
water level.
2. Water tank indicator light will not light up when water tank or filter are
not properly installed. No steam will be produced even if steam button is pressed.
Water tank indicator light
1. Fill water tank with clean water refer to above filling instruction. For better
performance, please immerse filter in water for several minutes before installing
it into the water tank.
2. Connect the appliance into a suitable socket outlet. Water tank decoration indicator
light lights up to indicate that the unit has been connected to the power supply.
3. Set temp setting knob to steam ironing position according to fabric setting chart
mentioned above. Heating indicator light illuminates to indicate the unit is
being heated up. When the heating indicator light turns off,the desired temperature
has been reached. It is ready for steam ironing. During use, heating indicator light
cycles from on to off, and then off to on. It does not indicate a defects or hazard, it is
just temperature maintenance.(For every first time use,
please pre-heat for 3 minutes)
4. Before every first time use, it is advised to clean iron unit as following methods:
Take the iron up from the base unit, press steam button underneath the handle to
allow steam ON for 20 seconds, and then OFF for 30 seconds, this cycle should be
repeated for 2 times. When temperature indicator light stops blinking, it is ready for
use.
5. After use, put iron unit back onto the base unit again, turn temperature control dial
to“MIN”, and then unplug the appliance from main socket .
6. Slide out the water tank and pour out the remaining water.
Note:
For every first time use, it is normal that’s a slight vibration sound may be
heard from electrical pump inside the base unit for a few seconds when steam
ironing has started. It is because there is air inside the filter, it will stop once
the air inside the filter has been pumped out.
Steam ironing
How to use your steam generator
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Swan SI9030 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Swan SI9030 in the language / languages: English as an attachment in your email.

The manual is 6,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info