782757

SureFlap Microchip Cat Flap - serie nr 2000000 plus Manual

5
Zoom out
Zoom in
Previous page
1/146
Next page
8
EN
7
Place some dry food or a treat inside the tunnel as close to
the clear plastic door as possible. The aim is to encourage
your pet to put its head inside the tunnel.
Tip: You could also try using catnip.
Batteries
Always use 4 good quality AA 1.5V alkaline batteries to ensure the best performance of
your cat flap. For example the Energizer or Duracell brands. When the batteries start to run
low, the indicator light will flash red once every 5 seconds.
To insert the batteries remove
the battery compartment
cover from the front of the
cat flap.
AA
Remove the battery compartment cover to reveal the 'Add a Pet'
button and press it for 1 second to enter the Add a Pet mode.
When your cat enters the tunnel to eat the food, the sensors
activate and the cat flap saves the microchip ID. Please see
page 23 - Help and support, for tips to encourage your cat to
use the cat flap.
Make sure the manual lock is set to
Position 1 before you begin. See
page 21 for more information on
the manual lock.
Insert the batteries into the compartment as shown,
with the + and - in the correct orientation. Then
replace the compartment cover.
Programming your cat flap
To start using your cat flap, you need to program your cat's microchip ID into the cat flap.
This process is only required once for each cat, as their ID will be stored in the cat flap's
memory. Follow the simple step-by-step guide to carry out this process. We strongly
advise doing this prior to fitting, however it is possible to program once already fitted
following the same steps detailed below.
The catch will now open, allowing your cat to pass through
the flap and the indicator light will flash once every second.
The cat flap is now in Add a Pet mode.
If your cat does not have a microchip, you can buy a Sure Petcare RFID Collar Tag from
surepetcare.com/accessories. To add the tag to the cat flap, repeat steps 2,3 and 5 by
holding the collar tag inside the tunnel, make sure you push the tag against the flap. Do
not wear metal jewellery during this process as it can interfere with the cat flap's sensors.
Once your cat’s microchip ID has been successfully added,
the flap reverts to standard operation. The indicator light will
stop flashing and the catch will lock (move up) when the cat
has moved away from the cat flap.
Step-by-step
Manual lock - Position 1
- Cancel programming your cat's microchip ID into the cat flap
(press the button again for 1 second, aer starting Add a Pet mode)
- Wipe the cat flap's memory (hold down for 10 seconds. The catch
will drop down and come back up once complete)
The 'Add a Pet' button has some extra features
Step-by-step continued
1
2
3
4
5
6
+ -+ -
+ -+ -
7
The cat flap can store up to 32 cat IDs so if you want to add
more than one just repeat the steps above for each cat. If
your cat flap is already installed, but you want to add an
additional cat then repeat steps 2-6.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for SureFlap Microchip Cat Flap - serie nr 2000000 plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of SureFlap Microchip Cat Flap - serie nr 2000000 plus in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 13.72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info