PART 1 • English
10
8.2.2.1 DiSEqC 1.2 positioner setup
Mount�
installed by a professional.
In “Antenna Setup” menu set “Positioner” to “DiSEqC 1.2” and press OK button to enter to “Antenna position” menu.
n Use CH p/q to move up and down in the list.
n Use VOL t/u to change the setting.
Satellite: select satellite position of which you would like to setup.
Transponder: select reference transponder which should be used for signal quality indication.
Move: when this item is highlighted press VOL t/u to move dish in East/West direction accordingly.
Save position: highlight this item and press OK to store current position of the dish for selected satellite. The �symbol shown
near menu item once position is stored.
Reference position: highlight this item and press OK if you need to turn dish to reference position (0 degree position).
Function: Set west limit / Set east limit – select it and press OK if you want to store current position of the dish as west / east
limit; Disable limit / Enable limit – select and press OK to disable / enable limits; Recalculate – select and press OK
to recalculate positions of all satellites based on adjustment for current satellite; Nudge west / Nudge east – select
and press OK for fine adjustment of the dish position; Nudge tilt up / Nudge tilt down – use this command if your
positioner support adjustment of elevation.
Antenna status: show you current status of the antenna (stopped, moving to East/West).
Signal Quality: show quality of signal for selected reference transponder. Adjust antenna position in order to get maximum level
of the Signal Quality.
n Press EXIT to go back to the previous mode.
8.2.2.2 USALS positioner setup.
�
installed by a professional.
In “Antenna Setup” menu set positioner to “USALS” and press OK button to enter to “Antenna position” menu.
n Use CH p/q to move up and down in the list.
n Use VOL t/u to change the setting.
Satellite: select satellite position of which you would like to setup.
Transponder: select reference transponder which should be used for signal quality indication.
My longitude: set longitude of your location.
My latitude: set latitude of your location.
Move: highlight this item and press t button to turn dish to the position corresponded to the selected satellite.
Press u button to stop dish.
Reference position: highlight this item and press OK if you need to turn dish to reference position (0 degree position).
Signal Level and Quality: show level and quality of signal for selected reference transponder. Adjust longitude and latitude of your
location in order to get maximum values of the Signal Level and Quality indicators.
n Press EXIT to go back to the previous mode.
8.2.3 Channel Search
Press OK on ‘Channel Search’ in the Setup Menu.
Set the Satellite, Tune Method, Transponder, Frequency, Symbol Rate, FEC and Function.
n Use CH p/q to move up and down the list.
n Use VOL t/u to change the setting.
Satellite Name: choose from the list of satellites selected in “Antenna setup” menu.
Tune Method: Main options are:
“Sat” – receiver will search channels according to stored list of transponders.
“Sat – NIT” - receiver will search channels according to stored list of transponders and in addition use network information.
This mode allows you to find all channels, even from new appeared transponders.
“TP” – this method is to search channels from one transponder.
