813428

Stovax View 7 Inset High Output Boiler Inset Manual

9
Zoom out
Zoom in
Previous page
1/44
Next page
9
User Instructions
5.10 The exact setting of the thermostat and the manual Air
Controls may need slight adjustment by trial and error to suit
requirements.
Operate the follow controls manually:
Primary Air Control
When burning solid fuel more Primary Air will increase the
heat output and burn the fuel more quickly.
Do not burn large amounts of fuel with the Primary Air
Control on a low combustion setting for long periods of
time. This causes tars and creosotes to build-up in the
appliance and flue system.
Airwash Control
A small amount of Airwash can sometimes help to keep the
glass clean but will reduce efficiency.
Experience establishes settings to suit personal preference.
Over-firing
When in use, burning the appliance at a high temperature
for a short period reduces tars and creosotes.
DO NOT OPERATE THE APPLIANCE WITH THE PRIMARY
AIR CONTROL OPEN FOR LONG PERIODS OF TIME AS
THIS COULD CAUSE OVER-FIRING AND MAY CAUSE
PERMANENT DAMAGE.
5.11 Only anthracite or smokeless fuels suitable for use in
closed appliances must be burnt in this appliance.
5.12 Do not burn bituminous coal, ‘petro-coke’ or other
petroleum based fuels as this invalidates the product
guarantee.
5.13 Do not load fuel above the log guard and the Secondary
Air Inlets at the back of the firebox, see Diagram 8.
Wood Burning
5.14 This section applies to burning wood on a Multi-fuel grate or
when a Woodburning tray is fitted.
Wood can be burnt on the multi-fuel grate, but if wood is to
be used constantly a Woodburning tray should be fitted, see
Section 6.
DO NOT BURN SOLID FUEL ON A WOODBURNING
TRAY AS THIS MAY CAUSE PERMANENT DAMAGE.
When fitted with a Multi-fuel grate only:
Do not de-ash the grate completely.
All Models:
Wood burns best on a bed of ash (approx. 25mm (1") deep).
5.15 Rake the embers evenly over the firebed and open the
Airwash Control fully for a few minutes before re-fuelling.
5.16 Do not refuel when a large amount of flames are present
in the firebox as this could cause smoke or flames to
spill into the room.
5.17 Add the correct amount of fuel, see Section 3.
5.18 Close the doors immediately after refuelling.
5.19 Burn new logs at a high temperature for a few minutes before
adjusting the Airwash Control. Refuel little and often for clean,
efficient burning. More Airwash will increase the heat output,
burn fuel more quickly and will help keep the glass clean.
Manually operate the following air controls using a
gloved hand or the tool provided.
11 Airwash: 30%
Primary Air: Closed
Thermostatic
Control: Adjust
5.20 Close the Primary Air Controls and adjust the Airwash
Control to approximately 30% open.
5.21 Control the temperature and hot water output using the
Thermostatic Control.
THERMOSTAT
This appliance is designed to be controlled by the
thermostat which regulates the rate fuel is burnt
and the amount of heat produced to hot water.
A trial and error approach will establish settings to
suit personal preference.
5.22 The thermostat operates by controlling combustion air
entering the boiler. The higher the thermostat setting the
hotter the temperature of the water leaving the boiler. The
lower the setting the lower the temperature of the water
leaving the boiler.
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stovax View 7 Inset High Output Boiler Inset at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stovax View 7 Inset High Output Boiler Inset in the language / languages: English as an attachment in your email.

The manual is 4.77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info