537132
74
Zoom out
Zoom in
Previous page
1/122
Next page
73MS 240, MS 260, MS 260 C
: Push the handlebar (1) out of its
seat on the underside of the
machine.
Remove the handlebar (1), check
it and replace if necessary.
: Position the handlebar (1) in its
seat (arrow) and insert the
screws.
165RA264 TG
1
165RA487 TG
1
: Position the handlebar (1) in its
seat on the side of the machine
(arrow) and insert the screws.
Check that the handlebar is
properly seated and then tighten
down all four screws firmly.
Reassemble all other parts in the
reverse sequence.
Tightening torques, b 3.5
11.6 Handlebar with Handle
Heating
The handlebar in these versions is
equipped with a heating system –
the electrical wires have to be
disconnected.
Troubleshooting, b 15.3.1
Apart from the electrical
connections, the removing and
installing procedures are the same
as for the handlebar without
heating, b 11.5.
Remove the carburetor, b 14.2
165RA266 TG
1
Take out the annular buffer/tank
housing mounting screws.
Annular buffer at ignition side,
b 11.3.
Annular buffer at clutch side,
b 11.2
Remove the interlock lever,
b 12.2
Remove the switch shaft,
b 12.1.1
Push the manifold out of the tank
housing, b 14.6.1
Pull off the impulse hose,
b 14.6.2
Remove the heater switch,
b 15.4
Remove the ground wire from the
housing cover, b 15.4.1
Lower the tank housing for easier
access.
During all the following procedures:
: To reduce the risk of a short
circuit, make sure the insulating
tubes completely cover the
connections.
165RA267 TG
74


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl MS 240 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl MS 240 in the language / languages: English as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stihl MS 240

Stihl MS 240 User Manual - German, Dutch, French, Italian - 196 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info