537132
58
Zoom out
Zoom in
Previous page
1/122
Next page
57MS 240, MS 260, MS 260 C
9.6 Short Circuit Wire
9.6.1 Testing
If the spark plug, ignition lead and
spark plug boot are in order, check
the short circuit wire.
Remove the fan housing, b 10.2
: Disconnect the short circuit wire
(1).
Connect the ohmmeter to ground
(arrow) and the short circuit wire
(1).
Set the switch shaft to "
0".
The resistance measured must be
about 0 Ω. If it is much higher, the
reason is a break and the wire has
to be replaced, b 9.6.2.
Set the switch shaft to "F".
The resistance measured must be
infinitely high. If not, fit a new short
circuit wire,
b 9.6.2.
If no fault can be found, check the
ignition system with the aid of the
troubleshooting chart, b 9.7.
Reassemble in the reverse
sequence.
165RA197 TG
1
9.6.2 Removing and Installing
Remove the shroud, b 8.4
Remove the fan housing,
b 10.2
Remove the carburetor, b 14.2
The ground and short circuit wires
are combined in a wiring harness.
: Pull the short circuit wire (1) out
of the retainer (arrow), disengage
and remove the connector (2).
: Take out the screw and remove
the ground wire (3).
Versions with handle heating
: Pull the wiring harness (1) out of
the guides (arrows).
: Pull the pin and socket connector
(2) out of the guide and separate
it.
165RA198 TG
1
2
3
165RA199 TG
1
2
: Pry out the grommet (arrow).
The wire for handle heating is also
included in the wiring harness and
grommet, and has to be removed as
well
b 15.8.
Pull the short circuit wire out of
the guide (arrow).
: Remove the connectors of the
short circuit wire (1) and ground
wire (2).
165RA200 TG
165RA482 TG
1
2
58


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl MS 240 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl MS 240 in the language / languages: English as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stihl MS 240

Stihl MS 240 User Manual - German, Dutch, French, Italian - 196 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info