537132
40
Zoom out
Zoom in
Previous page
1/122
Next page
39MS 240, MS 260, MS 260 C
Push the manifold (1) on to the
intake stub.
: Line up the manifold (1)
– the tab must be pisitioned as
shown in the illustration (arrow).
Position the hose clamp so that
the screw head (arrow) points
toward the clutch side.
: Push the hose clamp on to the
manifold.
Turn the hose clamp until the
screw head is below the lower
cylinder fin (arrow).
165RA034 TG
1
165RA071 TG165RA035 TG
a
: Tighten the screw until the gap
"a" between the two ends of the
hose clamp is about 5 to 6 mm.
: Inspect and clean the sealing
face (arrow) and remove any
gasket residue.
Check the sealing faces on the
cylinder intake and exhaust
ports.
The sealing faces must be in perfect
condition. If the sealing faces are
damaged, install a new cylinder.
: Slide the wooden assembly block
(1) 1108 893 4800 between the
piston and crankcase.
165RA072 TG165RA073 TG
1
Lubricate the piston, piston rings
and cylinder wall with oil, b 17
: Use the clamping strap (1)
0000 893 2600 to compress the
rings around the piston.
Check correct installed position
of rings, b 8.8
Apply the clamping strap (1) so that
the piston rings do not project
beyond the cylinder wall.
: Align the cylinder so that the
intake port (arrow) points toward
the rear handle.
While sliding the cylinder over the
piston, hold the clamping strap
tightly around the piston so that the
rings do not project – they might
otherwise break.
: Slide the cylinder over the piston,
the clamping strap moves
downwards at the same time.
165RA074 TG
1
165RA079 TG
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stihl MS 240 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stihl MS 240 in the language / languages: English as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stihl MS 240

Stihl MS 240 User Manual - German, Dutch, French, Italian - 196 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info