Manual Stiga ESTATE 3084 H (page 71 of 118) (English, German, Dutch, French, Italian)

608479

71

Zoom out

Zoom in

Previous page

1/118

Next page

13

IMPORTANT In order not to compromise the

efficiency of the electromagnetic clutch:

– do not let the clutch come into contact with oil;

– do not spray pressurised water directly on the

clutch unit;

– do not clean the clutch with petrol.

Now remove the grass catcher, empty and rinse

it, then place it where it can dry quickly.

b) To clean the upper part of the cutting-

means assembly:

– lower the cutting-means assembly completely

(position «1»);

– blow a jet of compressed air through the right

and left guard openings. Fig. 5.11)

5.4.11 Storage and inactivity

for long periods

If you intend not to use the machine for a long

period (more than 1 month), disconnect the

battery cables and follow the instructions in the

engine instruction manual.

Fig. 5.12) Empty the fuel tank by disconnecting

the tube (1) situated at the inlet of the fuel lter

(2), and collect the fuel in a suitable container.

Reconnect the tube (1) making sure you position

the clamp properly (3).

Put the machine away in a dry, sheltered place

and preferably covered with a cloth (see 8.5).

IMPORTANT The battery must be kept in a

cool and dry place. Before a long storage period

(more than 1 month), always charge the bat-

tery, and then recharge before using again (see

6.2.3).

The next time the machine is used, check that

there are no fuel leaks from the tubes, fuel stop-

cock or carburettor.

5.4.12 Circuit board protection device

The electronic circuit board has a self-resetting

protector which breaks the circuit if there is a

fault in the electrical system. This will stop the

engine and switch o the light.

The circuit automatically resets after a few sec-

onds but the cause of the fault should be ascer-

tained and dealt with to avoid reactivating the

protection device.

IMPORTANT To avoid activating the protec-

tion device:

– do not invert the leads on the battery terminals;

– do not use the machine without its battery or

damage may be caused to the charge regula-

tor;

– be careful not to cause short-circuits.

5.5 USING ON SLOPES (Fig. 5.13)

Observe the indicated limits (max 10° - 17).

WARNING! Take care when beginning

forward movement on sloping ground to

prevent the risk of tipping up. Reduce the

forward speed before going on a slope, par-

ticularly downhill.

DANGER! Never switch to reverse gear

to decrease speed when going downhill: this

could cause loss of control of the machine,

especially on slippery ground.

Mechanical transmission

DANGER! Never ride the machine on

slopes in neutral or with the clutch out!

Always shift into a low gear before leav-

ing the machine at a standstill and unat-

tended.

Hydrostatic transmission

Drive down slopes with your foot o the drive

pedal (see 4.32) to use the braking eect of

the hydrostatic transmission when the trans-

mission is not engaged.

5.6 SUGGESTIONS FOR MAINTAINING A

NICE LAWN

1. To keep a lawn green and soft with a good

appearance, it should be cut regularly with-

out damaging the grass. A lawn can be com-

posed of dierent types of grass. If the lawn

is cut frequently, grass and roots grow more

vigorously, forming a solid grassy bed. If the

lawn is cut is less frequently, higher grass

and weeds start growing (clover and daisies,

etc.).

2. It is always better to cut the grass when dry.

3. The cutting means must be in good condition

and well sharpened so that the grass is cut

straight without a ragged edge that leads to

yellowing at the ends.

4. The engine must run at full speed, both to

ensure a sharp cut of the grass and to get the

necessary thrust to push the cuttings through

the collector channel.

5. The frequency of mowing should be in rela-

tion to the rate of growth of the grass, which

should not be left to grow too much between

one cut and the next.

1

the mower wont go into mowing drive when I lift the button
Submitted on 7-3-2023 at 06:09
Reply Report abuse
The engine cuts out if the forward pedal is pushed down.. it is not the seat cut out or the grass catcter off Submitted on 23-12-2022 at 01:10
Reply Report abuse
I need information on replacing the Deck cutting belt Submitted on 28-5-2020 at 15:47
Reply Report abuse
my stiga 3084H , with the wheels straight , the steering wheel is no longer aligned .The steering rods don't appear to be bent. Could the steering cog have jumped a tooth on the rack?
Dave Submitted on 8-12-2018 at 20:29
Reply Report abuse
HELP My stiga estate 3084h mower starts without having to press the foot brake and occasionally stops after a few seconds then it will not start leave it for a couple of minutes and it will start I have changed all the safety micro switches but it is still the same any suggestions please
Thank you in advance Submitted on 2-7-2018 at 08:44
Reply Report abuse
How do I level the cutting deck, it is 20mm higher on one side Submitted on 4-9-2017 at 16:25
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

Register

Register getting emails for Stiga ESTATE 3084 H at:

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stiga ESTATE 3084 H in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga ESTATE 3084 H

Stiga ESTATE 3084 H User Manual - Danish, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish - 192 pages

Stiga ESTATE 3084 H Additional guide - All languages - 1 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info