Manual Stiga ESTATE 3084 H (page 70 of 118) (English, German, Dutch, French, Italian)

608479

70

Zoom out

Zoom in

Previous page

1/118

Next page

12

Whatever the conditions, always reduce the

speed if you notice a drop in engine speed – if

you travel too fast compared to the amount of

grass being cut, you will not be able to mow the

grass well.

Disengage the cutting means and raise the

cutting-means assembly as high as possible

whenever you need to get past an obstacle

5.4.6 Emptying the grass catcher

(Fig. 5.9)

NOTE The emptying of the grass catcher can

only be done with the cutting means disengaged,

otherwise the engine stops.

Do not let the grass catcher become too full as

this may block the collection channel.

When the grass catcher is full you will hear a

warning sound; at this point:

– disengage the cutting means (see 4.5) and

the warning sound will stop;

– lower the engine speed;

– shift into neutral (N) (see 4.22 – Mchanical

transmission or 4.32 - Hydrostatic transmis-

sion) and stop moving forward;

– engage the parking brake on slopes;

– pull out the lever (1 - if tted) or grasp the rear

handle (1a) and tip up the grass catcher to

empty it;

– close up the grass catcher so that it hooks

onto the pawl (2).

5.4.7 Unblocking the collector channel

Cutting very tall or wet grass, particularly at ex-

cessively high speed, can clog up the collector

channel. If this happens proceed as follows:

– stop forward movement immediately, disen-

gage the cutting means and stop the engine;

– remove the grass catcher or the rear dis-

charge guard;

– remove the grass cuttings; you can reach

them from the channel discharge opening.

WARNING! This job must only be per-

formed with the engine turned off.

5.4.8 End of mowing

When you have nished mowing, disengage the

cutting means, reduce the engine speed and

ride the machine with the cutting-means assem-

bly in the highest position.

altezza.

5.4.9 End of work

Stop the machine, put the accelerator lever in

the «SLOW» position and turn o the engine by

putting the ignition key into the «OFF» position.

When the engine has stopped, close the fuel

stopcock (1) (if tted) (Fig. 5.10)

WARNING! To avoid backfire, put the

accelerator in the «SLOW» position for 20

seconds before stopping the engine.

IMPORTANT To keep the battery charged, do

not leave the ignition key in the «ON» or «HEAD-

LIGHTS ON» position when the engine is not

running.

5.4.10 Cleaning the machine

After each mowing session, clean the outside

of the machine, empty the grass catcher and

shake it to remove residual grass and earth.

Clean the plastic parts of the body with a damp

sponge using water and detergent, taking care

not to wet the engine, the electrical parts or the

electronic circuit board located under the dash-

board.

IMPORTANT Never use hose-nozzles or

harsh detergents for cleaning the body and en-

gine!

WARNING! Do not let debris and dried

grass accumulate in the upper part of the

cutting-means assembly in order to maintain

maximum machine efficiency and safety

levels.

After each use, clean the cutting-means as-

sembly thoroughly to remove any grass remains

or debris.

WARNING! Wear eye protection and

keep people or animals away from the sur-

rounding area when cleaning the cutting-

means assembly.

a) When washing the inside of the cutting-

means assembly and the collector channel, the

machine must be on rm ground with:

– the grass catcher or the rear discharge guard

tted in place;

– the operator seated;

– the cutting-means assembly in position «1»;

– the engine running;

– the transmission in neutral;

– the cutting means engaged.

Connect a water hose to each of the pipe ttings

(1) one at a time and run water through each one

for a few minutes, with the cutting means mov-

ing (Fig. 5.11)

1

the mower wont go into mowing drive when I lift the button
Submitted on 7-3-2023 at 06:09
Reply Report abuse
The engine cuts out if the forward pedal is pushed down.. it is not the seat cut out or the grass catcter off Submitted on 23-12-2022 at 01:10
Reply Report abuse
I need information on replacing the Deck cutting belt Submitted on 28-5-2020 at 15:47
Reply Report abuse
my stiga 3084H , with the wheels straight , the steering wheel is no longer aligned .The steering rods don't appear to be bent. Could the steering cog have jumped a tooth on the rack?
Dave Submitted on 8-12-2018 at 20:29
Reply Report abuse
HELP My stiga estate 3084h mower starts without having to press the foot brake and occasionally stops after a few seconds then it will not start leave it for a couple of minutes and it will start I have changed all the safety micro switches but it is still the same any suggestions please
Thank you in advance Submitted on 2-7-2018 at 08:44
Reply Report abuse
How do I level the cutting deck, it is 20mm higher on one side Submitted on 4-9-2017 at 16:25
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

Register

Register getting emails for Stiga ESTATE 3084 H at:

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Stiga ESTATE 3084 H in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Stiga ESTATE 3084 H

Stiga ESTATE 3084 H User Manual - Danish, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish - 192 pages

Stiga ESTATE 3084 H Additional guide - All languages - 1 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info