754688
6
Zoom out
Zoom in
Previous page
1/15
Next page
6760.180 | 17.10
ENGLISH
5 Installation
Avoid installation locations in direct sunlight, or next to stoves, heating, or
similar heat sources.
The floor at the installation location should be level and flat. Install the device
a sufficient distance from the wall so that the lid can open and close unhin-
dered.
Do not cover the gap between the lower edge of the cabinet and the floor,
because the chiller must be provided with cooling air.
The minimum clearance between the ventilation grill and the wall is 20 cm .
This clearance must always be maintained and the ventilation grill must not
be covered.
Do not obstruct the outer cladding of the device. A minimum all-round clear-
ance of 20 mm must be maintained to ensure adequate heat dissipation.
According to the EN 378 standard, the installation room for the device must
have a volume of 1 m³ per 8 g of R 290 coolant, so that if a leak develops in
the cooling circuit no inflammable gas-air mixture can result in the installation
room. Information on the coolant volume can be found on the type plate.
Do not connect the device together with other devices using an extension
cable – danger of overheating.
Take note of the cable cross-section information in the table below when extend-
ing the power cable.
Cable sizes 12 V
Cable length
24 V
Cable length
Cross-section AWG
mm² Gauge m ft. m ft.
2.5 12 2.5 8 5 16
412 4 13 8 26
610 6 19.5 12 39
6 Connection
The power type and voltage at the installation location must match the specifi-
cations on the type plate. The type plate is located on the upper right side wall
of the cabinet.
WARNING
Risk of electrical shock and fire when connected to a voltage supply outside
the specified range.
XThe cable provided must be connected to a 12 V or 24 V DC connection at the
battery or the charge controller.
XPlease pay attention to the correct polarity: blue (−) and red (+).
NOTES
Energy saving
XAvoid long and unnecessary opening of the lid.
XAllow warm food to first cool to room temperature before storing it in the
device.
XDefrost the device when an ice layer has formed. This improves the cooling
transfer and reduces the energy consumption.
Operation as refrigerator
XIf the device is used as a refrigerator (inside temperature above 0 °C / 32 °F),
humidity will condense on the interior container.
Drain condensed water periodically (see chapter 13 Defrosting). Do not store
moisture-sensitive goods directly on the bottom of the refrigerator but in a
basket or with distance to the bottom.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Steca PF240-H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Steca PF240-H in the language / languages: English as an attachment in your email.

The manual is 1,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Steca PF240-H

Steca PF240-H User Manual - German - 15 pages

Steca PF240-H User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info