720594

Stanley STR-4 in 1 Manual

40
Zoom out
Zoom in
Previous page
1/240
Next page
40
Disassembly of the Tubes
1. Place the hedge cutter on a clean flat surface and
loosen the screw of the connection piece. Pull the latch
protection from the notch.
2. Push the latch down. This releases the lock of the
connecting piece. See A41.
3. Pull the upper tube out of the connection piece.
Mounting of the cutting attachment
Warning!
The blades are very sharp. Do not handle the blades,
if the blade cover is not covered. Always wear gloves
when you work with or in the vicinity of the blade.
1. Make sure that the cutting attachment in the storage/
transport position is locked (folded back) and the blade
cover is pulled over the blade.
2. Push the outer tube up to the limiting stop in the
clamping of the transmission housing.
The outer tube must be fully pushed into the
transmission housing. If you feel a resistance before
the limiting stop, turn the outer tube until the splines of
the inner main shaft (drive shaft) snaps into place in the
transmission housing and push the outer tube up to the
limiting stop.
3. Turn the gearbox housing/Cutting attachment so that
the index bolt is aligned in an upright position over the
hole
. The cutting attachment is located in the reverse
position (in the bearing position/transport position).
A42
1
2
3
1). Blade cover
2). Align with hole in outer tube and tighten the index
screw
3). Tighten the clamping screw finally
A43
2
1
1). Place the hand protection so that the tip of the
cutting attachment in the recess (if the hedge cutter is in
the warehouse/transport position).
2). Tighten clamping
4. Use an Allen key (4 mm), to first tighten the index bolt
on the gearbox housing and then the clamping screw.
5. Align the hand protection in such a way that the tip
of the cutting attachment is lying correctly in the recess.
Make sure that the cutting attachment is not jammed in
the slot. Then tighten the screw of hand protection with
a screwdriver.
A41
G
B
… 40 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley STR-4 in 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley STR-4 in 1 in the language / languages: English, German, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 9,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info