720594

Stanley STR-4 in 1 Manual

42
Zoom out
Zoom in
Previous page
1/240
Next page
42
Setting the hedge cutter on the desired cut
angle
Warning!
Do not take hold of the blade when the engine is
running. The blade can vibrate, even when the engine is
idling
A47
Different blade angles are possible. The hedge shears
can be set in 12 different angles from 80° to -90° in
respect to the outer tube, see A 47. On the previous
page you will find out how you will set them. Make sure
that the latch is securely engaged after each setting.
Prepare the hedge shears for storage or for
transport
Warning!
If you bring the hedge cutter to the storage position, the
engine should not be running.
1. If the engine is switched off, pull the blade cover over
the blade.
2. Turn the hedge cutter so that it runs parallel to the
tube (see steps on the previous page). Make sure that
locking and unlocking is securely snapped into place.
See A 48.
3. Make sure that the blade cover is put on before you
store or transport the device.
1
A48
1. Transmission housing turned in the storage/transport
position
Safe to Use
The device is meant for cutting the hedges.
Do not use the device for any other purpose. Do not
attempt to cut hard objects made of stone, metal, plastic
or other hard objects.
The use of the hedge cutter for any other purpose might
result in property damage or serious personal injury.
Preparation:
• Wear appropriate protective work clothes and
protective equipment, see Section “Safety Instructions”.
• Select the working position, in which you are
protected as best as possible against falling objects
(branches, etc.).
• Start the engine.
• Fasten the belt.
Never stand directly under the branch that you want to
cut. Pay attention to falling branches. Remember that
a branch can spring back after falling to the ground.
Working position:
Hold the control lever with your right hand and the shaft
with your left hand. Your left arm should be stretched
out in a comfortable position.
Caution: Relax when you feel exhausted.
G
B
… 42 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley STR-4 in 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley STR-4 in 1 in the language / languages: English, German, Danish, French, Italian, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 9,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info