720580
22
Zoom out
Zoom in
Previous page
1/233
Next page
22
moving parts from freezing. Engage the auger
to clear any remaining snow from inside
the housing. Rotate the discharge chute to
prevent it from freezing. Stop the engine, wait
for all moving parts to stop, and remove all
ice and snow from the snow thrower. With
the engine off, pull the recoil starter handle
several times to prevent the recoil starter from
freezing up.
8. Maintenance and Care
Engine
Refer to the Engine Operator’s Manual.
Lubrication
Auger Gearbox
The gearbox was filled with lubricant to the
proper level at the factory. Unless there is
evidence of leakage or service has been
performed on the gearbox, no additional
lubricant should be required. If lubricant is
required, use GL-5 or GL-6, SAE85-95, EP
gear oil lubricant. Do not use synthetic oil.
General Lubrication
Lightly lubricate all moving parts of the
machine at the end of the season or every 25
operating hours.
Do not allow grease or oil get on friction
disc, friction plate or belts. Do not
excessively oil the machine; extra oil may
enter the traction drive and cause the traction
drive belt to slip.
When lubricating auger shaft, remove shear
pins to apply oil inside the shaft and around
spacers and flange bearings found at either end
of the shaft.
Remove the wheels to apply grease
the wheel shaft.
Battery (if so equipped)
Battery is maintenance-free. Do not tamper
with or attempt to open battery.
Keep battery and its terminals clean.
1. Remove battery cover.
2. Detach the negative (black) battery cable from
the battery first to prevent a short circuit, then the
positive (red) battery cable.
3. Take the battery out of the tray.
G
B
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SPT-270-720 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SPT-270-720 in the language / languages: English, German, French, Italian, Finnish as an attachment in your email.

The manual is 23,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info