720580

Stanley SPT-270-720 Manual

20
Zoom out
Zoom in
Previous page
1/233
Next page
20
To unlock wheel, slide it inward and insert the
axle pin through the outer axle hole, but not
through the wheel hub.
To lock wheel, slide it outward and insert the
axle pin through the hole in the wheel hub and
the outer axle hole.
Starting and Stopping the Engine
Before starting the engine, check engine
oil level and ensure the engine is served as
described in the Engine Manual with the
snow blower.
Cold Start – Electric Starter (120V or 230 AC)
(if so equipped)
The engine is equipped with both A.C. electric
starter and a recoil starter. The electric starter
is equipped with a three-wire power cord and
plug and is designed to operate at the voltage
shown in the label.
Do not use the electric starter if
your household voltage different
from the one shown on the electric
starter.
1. Insert safety ignition key into ignition slot
until it clicks. Do not turn the key.
2. Be sure fuel shutoff valve is in the OPEN
position.
3. Move choke control to FULL position.
4. Push the primer 2 or 3 times. When temperature
is below -25oC (15oF), additional priming may
be needed. When temperature is above 10oC
(50oF), priming is not necessary.
Over priming may cause flooding,
preventing the engine from starting.
If you do flood the engine, wait a
few minutes before attempting to
start and do not push the primer.primer.
Some snow engine is not equipped
with primer as priming is not needed
for such engine.
5. Connect the extension cord to the engine.
6. Plug the other end of the extension cord
into a three-wire grounded receptacle.
7. Push starter button until engine starts.
To prevent damaging the electric starter, do
not run it more than 5 continuous seconds
each time you try to start. Wait 10 seconds
between each attempt.
8. When the engine starts, release the starter
button and slowly move the choke control
to the OFF position.
9. Disconnect the extension cord from the
receptacle first, then from the engine.
Cold Start – Electric Starter (12V DC) (if so
equipped)
1. Be sure fuel shutoff valve is in the OPEN
position.
2. Move choke control to FULL position.
3. Push the primer 2 or 3 times. When
temperature is below -25oC (15oF),
additional priming may be needed. When
temperature is above 10oC (50oF), priming
is not necessary.
Over priming may cause flooding,
preventing the engine from starting. If you
do flood the engine, wait a few minutes
G
B
… 20 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SPT-270-720 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SPT-270-720 in the language / languages: English, German, French, Italian, Finnish as an attachment in your email.

The manual is 23,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info