720580

Stanley SPT-270-720 Manual

19
Zoom out
Zoom in
Previous page
1/233
Next page
19
cable should have very little slack.
Auger must stop within 5 seconds when the
auger clutch lever is released. If auger clutch
does not engage or disengage properly, adjust
auger clutch before operation.
If the snow thrower’s drive is disengaging
intermittently during operation, or it drives
when you release the drive clutch lever, adjust
the drive clutch before operation.
Both auger clutch and drive clutch can be
adjusted as follows:
1. Loosen jam nut on adjustment turnbuckle.
2. Turn the adjustment turnbuckle up and down to
increase cable tension or provide more slack.
3. Retighten jam nut.
Chute Bracket
If the spiral at the bottom of the chute crank
lever is not fully engaging with the chute
assembly, the chute bracket can be adjusted.
To do so:
1. Loose the two nuts which secure the chute
bracket and reposition it slightly.
2. Retighten the nuts.
Freewheeling and Self-Propelling
To do so:
1. Loose the two nuts which secure the chute
bracket and reposition it slightly.
2. Retighten the nuts.
Freewheeling and Self-Propelling
Use the axle lock pin to lock or unlock the
right or left wheel. Lock both wheels to
increase traction; unlock one wheel to allow
for easier turning of the unit; unlock both
wheels for freewheeling.
G
B
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Stanley SPT-270-720 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Stanley SPT-270-720 in the language / languages: English, German, French, Italian, Finnish as an attachment in your email.

The manual is 23,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info