708059

Spektrum DX8 Manual

29
Zoom out
Zoom in
Previous page
1/42
Next page
29

Rotate the roller to adjust the selected point to the desired output position. Note
the position on the graph at the left of the screen.
Repeat this for all desired points.

Highlight EXPO then press the roller to access the Pitch Curve Expo function.
Select Inh or Act to inhibit or activate the Expo function. Press the roller to accept.

The DX8 offers eight mixes in airplane model type. There is an Elevator to Flap
mix, Aileron to Rudder mix, and six user-programmable mixes that allow the
mixing of any channel to any other channel. Programmable mixes include a trim
offset function that adjusts the mix crossover point and a trim include function
that applies the master’s trim to the slave channel. You can assign Mixes to the
following switches or flight modes:
- Off
 - Always on
 - Gear switch
- Aileron dual rate switch
Ele - Elevator dual rate switch
Rud - Rudder dual rate switch
 - Flight mode 1
 - Flight mode 2
 - Flight mode 1 and 2
Mid - Flap switch mid position
 - Flap switch land position

With the transmitter on and the main or telemetry screen displayed, press the
roller. The Function list displays.
Rotate the roller to highlight Mixing then press. Note that the Elevator to Flap mix
appears on the screen if the appropriate wing type is selected.

Use Aileron to Rudder mixing to overcome adverse yaw characteristics with
certain types of aircraft such as the J3 Cub and make coordinating turns easier.

IIf you accessed the flap option in wing type in the system setup mode, the
elevator to flap mix will display. Rotate the roller to highlight ELE > FLP then
press. Now rotate the roller to select Ail > RUD and press. The aileron to rudder
Mix screen appears.

Rotate the roller to highlight Sw: at the bottom of the screen. Press the roller to
access the switch select function then select the desired switch to turn on/off the
aileron to rudder mix. If you select On, the mix will always be on.

Rotate the roller to highlight the rate values then press. Note that both rates are
boxed. Moving the aileron stick right or left causes the right or left value only to
be highlighted so you can adjust the values individually. Move the aileron stick
in position to highlight the desired rates then rotate the roller to adjust the value.
Note that positive + and negative - values reverse the direction of the mix. Press
the roller to accept the rate.
Verify the aileron to rudder mix is working properly and in the correct direction by
placing the active switch in the active position and moving the aileron stick noting
the rudder position. If the rudder moves in the opposite direction than desired,
the opposite value (positive vs. negative value) is needed.
Note: the Elevator to Flap mix operates in the same fashion as alieron to
rudder mix.

Programmable mixes allow any channel to be mixed to any other channel or to
itself. Popular programmable mixes include rudder to steerable nose wheel, dual
rudder mix, dual elevator mix, rudder to aileron and rudder to elevator mix for
knife edge correction.
EN
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spektrum DX8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spektrum DX8 in the language / languages: English as an attachment in your email.

The manual is 5,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spektrum DX8

Spektrum DX8 Quick start guide - English - 100 pages

Spektrum DX8 User Manual - German - 42 pages

Spektrum DX8 User Manual - French - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info