810449
21
Zoom out
Zoom in
Previous page
1/28
Next page
GB
GB 21
5.3 MAINTENANCE OF THE HEAT EXCHANGER
At regular intervals during the heating season, the water pressure of the
heating system must be checked. The Nova E H2O must only be operated in
a completely filled and ventilated state.
The technical heating inspection and checking of all safety devices (thermal
discharge safety device, safety valve, etc.) and of the other components,
such as the pump thermostat, is required yearly before the heating season.
The instructions in the installation and operating manuals provided by the
respective manufacturers of the components must be complied with. This
check must only be executed by a specialised company that can ensure the
functionality of the individual components. We recommend that you con-
clude a maintenance contract with your specialised company. The executed
yearly safety inspections must be documented by your specialised company
in the commissioning protocol! If there is a complaint, documentation of the
maintenance tasks that have been executed must be submitted to service
personnel.
Access to the water-side connections of the Nova E H2O must be possible
via the heating chamber (see Fig. 2a).
Operation without combustion chamber lining is not permitted!
6. ADVISOR
Note: The fireplace must not be used as a waste incinerator! In addition,
the fireplace is a temporary burning fireplace. Continuous burning can-
not be achieved even through withdrawal of the combustion air and is not
permitted!
You can solve the following problems on your own:
Problem description Solution
Thermal discharge safety device
trips constantly (constant water
outflow through the discharge).
The water heat exchanger cannot
dissipate heat to the heating
system.
- The buffer tank is „full“. Withdraw heat from the tank.
- Check function and settings of the pump thermostat and the
return flow boost.
- Set the pump one level higher (higher flow rate).
- Circulation pump does not run. Is the pump or power connection
defective?
- Return flow temperature too high, < 75°C.
- Check whether the shut-off elements are closed.
- Is sufficient heating water available?
- Ventilate.
Thermal discharge safety device
drips.
- Contamination of the discharge safety device.
- Flush the thermal discharge safety device by activating the red
button on the fitting.
- Check the seat of the connection seals and the piston (see the
manual provided by the manufacturer).
- If necessary, integrate filter in the system upstream of the
discharge safety device (pay attention to the minimum flow!)
Gurgling noises, boiling noises
in the water-bearing parts of the
Nova E H2O (Air in the system).
- Check system pressure.
- Ventilate system via the vent. For newly filled or topped up
systems it takes some time for all the air to accumulate. Often
ventilating once does not suffice.
Radiators do not warm up. - Close radiator thermostats when the set room temperature is
reached. The convection heat of the fireplace is distributed in
the air composite.
- Depending on the configuration, the heating system is inert. It
takes some time until the heating system dissipates its heat.
- Have the heating system hydraulically calibrated.
- Check heating circuit pump for function.
- Ventilate the system.
Increasing and faster contamina-
tion of the combustion chamber
lining and of the glass ceramics.
The combustion chamber lining no
longer burns free. Fire can only be
ignited with difficulty.
· Remove deposits in the heat exchanger and in the connecting
line to the chimney.
· Pay attention to correct firing, wood feed quantity, wood moisture
content < 20%.
· Check chimney draught.
· Check return flow temperature boost.
Draught problems If there are draught problems, the turbulators in the flue gas
channels can be removed. However, through this measure, a lower
capacity on the water-side of approx. 1 - 4% is possible.
For other problems, contact your fireplace constructor / heating specialist!
Only use the spare parts offered by the manufacturer!
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Spartherm Nova E H2O at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Spartherm Nova E H2O in the language / languages: English as an attachment in your email.

The manual is 3.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Spartherm Nova E H2O

Spartherm Nova E H2O User Manual - German - 28 pages

Spartherm Nova E H2O User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info