Signal light: installation + connection
Please note!
Connect all signal lights to the signal light controller.
Permissible cable cross-sections for all terminals:
1 mm² ... 2.5 mm²
Inside button:
Installation + connection
When pushing the button, the user should not stand in the
door's travel range and the user must have a clear view of the
door.
• Never run button cable (length 7 m) along a power cable as this can
cause the control unit to malfunction. The control unit is shipped with the
button cable connected.
• Lay button cable and secure in position.
• Install push-button (1) in an appropriate, easily accessible location in
the garage. Minimum height from the floor: 1.6 m
• Install button cable (2) in garage. Connect end of cable to button (1).
Alternatively a pull-cord switch (3) can be installed. Minimum
height of the cable end from the ground: 1.6 m