658837
25
Zoom out
Zoom in
Previous page
1/46
Next page
Starting / Stopping the engine - Starting settings and start-up, - Engine will not start
ENGLISH 25
E
N
G
[Basic settings (chain brake, standard or winter operation, stop switch, primer) as described in
the previous paragraph. ]
Cold start:
Pull the choke lever (7) (this also activates the part-throttle setting) [part throttle control
pin (8) is pulled along].
Using the starter handle, start the engine until you hear it briefly ignite.
Note: the engine cannot start up and continue running while the choke lever is pulled
out.
! After the first audible ignition, immediately:
Press the choke lever back in again.
Continue starting until the engine runs
The engine is then running in part throttle (visible from the part throttle control pin).
Briefly operate the throttle control to cancel the part control setting (the part throttle
control pin jumps back in again).
The engine will then continue to run at idle speed.
Note: If the choke lever is not pushed back in when you hear the first audible ignition, the combustion
chamber can quickly become saturated if start-up is repeated with the choke lever pulled out. In this
case you will be unable to start the device. Please refer to the instructions given in section 5.3,
“Engine will not start”.
Warm start:
Start the engine in idle setting with the choke not pulled out,
or start it in !
part throttle setting:
by pulling the choke out and pressing it back in again [the part throttle setting is
activated as a result, which is visible from the pulled-out part throttle control pin (8)]
Start the engine until it runs, then briefly operate the throttle control to cancel the part
throttle setting (the part throttle control pin jumps back in again).
The engine then runs on at idle speed.
5.3 Engine will not start
If the engine fails to start after several attempts, check whether all adjustments described above have
been correctly carried out, particularly that the stop switch is not in the "0" position. Try starting once
again. The combustion chamber will be flooded, if the engine still fails to start.
In that case we recommend you proceed as follows:
Remove the cowl. (chapter. 3.4)
Pull the spark plug cap off the spark plug.
Remove the spark plug and dry fuel mixture from the electrodes.
Move the throttle lever up to full throttle. Pull the starter handle several times (with removed spark
plug) to clear the combustion chamber.
Move the throttle lever down to idling position, refit the spark plug, the plug cap and the cowl.
Repeat the starting process according to the starting settings for a warm start in part throttle
setting.
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 651 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 651 in the language / languages: English as an attachment in your email.

The manual is 1,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info