658837
24
Zoom out
Zoom in
Previous page
1/46
Next page
Starting / Stopping the engine - Starting positions, - Starting settings and start-up
ENGLISH 24
E
N
G
5. Starting / Stopping the engine
5.1 Starting positions
Take off the chain guard.
Place the power tool on level ground which is free of
obstructions and make sure that the cutting tool is not
touching anything.
Place one foot in the rear handle to secure the saw on
the ground.
Use one hand to firmly hold the saw by the front
handle.
Use your other hand to pull the starter handle.
You must make absolutely sure that there is no risk
of contact between the guide bar and any part of
your body.
(schematic diagram)
Alternative way to hold the saw while starting it up (for experienced users only):
Take off the chain guard.
Firmly grasp the rear handle between your
thighs.
Use one hand to firmly hold the saw by the front
handle.
Use your other hand to pull the starter handle.
You must make absolutely sure that there is no
risk of contact between the guide bar and any
part of your body.
(schematic diagram)
Always start by pulling the starter handle carefully until a first resistance is felt (top dead centre
point of the piston), and then pull it through in a fast and strong motion.
You must use a confident and firm action to start the engine.
If you are unsure about anything, please ask an expert for advice or attend a course on safe
handling of the power tool (e.g. at a specialist forestry training centre or similar).
5.2 Starting settings and start-up
Please read the safety instructions before starting up the device.
Basic settings (for cold starts and warm starts)
Before starting the engine, activate the chain brake to block the chain.
Depending on the conditions, set the sliding switch (33) either to standard or winter
operation (see Chapter 3.4, "Components and functional parts under the cowl")
Move the stop switch (18) upwards into its operating position.
If necessary, press the primer (21) to pump fuel (see Chapter 3.8, "Functional components for
start-up").
Depending on the version: Before every starting attempt press the decompression valve (22)
(see Chapter 3.8, "Functional components for start-up").
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solo 651 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solo 651 in the language / languages: English as an attachment in your email.

The manual is 1,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info