730380
85
Zoom out
Zoom in
Previous page
1/108
Next page
169168
GB GB
Problem Possible cause Solution
Espresso is not
dispensed and
flows out too
slowly.
The holes in the sieve
of the brewing head are
clogged.
The openings of the filter
inserts are clogged.
The grind size is too fine.
The ground coffee was
tamped too strongly.
The dispensed amount of
espresso is too small.
The water tank is not
installed correctly.
There is too little water
in the tank so that the
pump can not suck in
any water.
Empty water tank
Take the portafilter out of the brewing
head and let hot water run through it
(press the or button). Should
the water run through the sieve irregu-
larly, descale the appliance as described
in the section “Descaling” on page 164.
Carefully and slowly turn the portafilter
out of the brewing head. Please note
that the pressure could cause hot splash-
es. Clean the holes in the filter insert
with a brush or the cleaning tool. Clean
the filter inserts as described in the sec-
tion “Cleaning” (p. 161).
Set the appliance to a coarser grind size
(higher number).
Use less pressure when tamping the
ground coffee.
Manually adjust a larger amount of
espresso. Please proceed as described in
the section “Programming the amount
of espresso” (p. 153).
Correctly install the water tank so that
it lies firmly against the back side of the
appliance.
Check the water level and, if required,
fill the water tank with fresh cold tap
water up to the MAX marking.
Fill the water tank up to the MAX mark-
ing with fresh cold tap water.
The machine
makes unusual
noises while mak-
ing espresso.
There is too little water
in the tank so that the
pump can not suck in
any water.
Check the water level. If required, fill the
water tank with fresh cold tap water up
to the MAX marking.
The machine does
not dispense
any hot water or
steam.
The steaming nozzle is
clogged.
Remove potential residues from the
opening of the steaming nozzle using
the large needle of the cleaning tool.
Problem Possible cause Solution
Milk is not prop-
erly steamed. Not enough steam. Remove potential residues from the
opening of the steaming nozzle using
the large needle of the cleaning tool.
The appliance
stops the opera-
tion.
The protection mecha-
nism of the electric grind-
er motor was triggered.
Switch the appliance off, pull the power
plug and let the appliance cool down for
approx. 60 minutes.
Should none of the above stated reasons apply, please contact Solis or a service
centre authorised by Solis.
85


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solis Grind and Iinfuse Compact 1018 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solis Grind and Iinfuse Compact 1018 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 24,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info