Manual Solis Grind and Iinfuse Compact 1018 (page 83 of 108) (English, German, Dutch, French, Italian)

730380

Zoom out

Zoom in

1/108

165164

GB GB

s

DESCALING

If your appliance requires a descaling cycle, the warning light starts ﬂashing. In

this case, please perform a descaling cycle as soon as possible. After approx. 2 litres

more have been extracted, the warning light lights up permanently. Now at the

latest, the descaling cycle has to be promptly performed.

ATTENTION: In the event of an alarm, you should descale your machine immediately

in order to prevent the functionality from being reduced or the coffee quality from

degrading. Repairs to the espresso machine relative to limescale problems are not

covered by the warranty if the descaling procedure described below is not performed

regularly.

Solis recommends descaling your Solis Grind & Infuse Compact espresso machine with

a mixture of SOLIPOL® special and water. Please use only SOLIPOL® special (art. no.

703.02) for descaling the machine. Damages caused by the use of improper desca-

ling agent are not covered by warranty.

When the descaling alarm is displayed, please proceed as follows:

1. Switch the appliance off with the On/Off button and disconnect the power plug.

Turn the portaﬁlter out of the brewing head.

2. Remove the water tank from the appliance and empty it out. Remove the Solis

water ﬁlter from the tank. Fill the water tank with 1.25 litres of water and

1.25 litres of SOLIPOL® special so that the tank is ﬁlled with 2.5 litres of descaling

solution. Place the water tank back on the rear of the appliance. Empty the drip

tray and reinsert drip tray and grid.

3. Place a large 2,5 litres container (e.g. a bowl or a baking mould etc.) on the

drip grid underneath the brewing head. The steam / hot water wand has to be

directed into the container.

4. Insert the plug. While the machine is switched off, simultaneously press and hold

both espresso buttons ( and ) and then immediately press and hold

the On/Off switch for 3 seconds. The descaling program starts and the descaling

solution in the tank runs through the brewing head and through the steam / hot

water wand. During the descaling process, the function lights of the two espresso

buttons ( and ) are ﬂashing as well as the descaling warning light.

Limestone residues are removed from the water circuit.

5. After multiple cycles and pauses, the descaling program is completed. The two

function lights of the espresso buttons ( and ) go out. Tip: The container

can be emptied out during the pauses (in case it does not hold 2,5 litres).

6. Take the water tank off and pour away the descaling solution if there is any left.

Rinse the water tank multiple times under running water. Reﬁll the clean water

tank with fresh, cold tap water.

7. Now, the machine has to be rinsed to remove the descaling agent residues.

Empty the container and the drip tray. Reinstall the drip tray and the grid. Place

the container back underneath the brewing head resp. the steam / hot water

wand.

8. Press and hold both espresso buttons ( and ) simultaneously for

approx. 3 seconds until they start ﬂashing, then release them. The rinsing

process starts and the water runs through the brewing head and the

steam / hot water wand. During the rinsing process, the buttons ( and

) as well as the descaling warning light are ﬂashing. After multiple

cycles and pauses, the rinsing process is completed and the appliance switches

off.

9. Take the water tank off, empty it out, rinse it with clear water and reinstall the

water ﬁlter. Then, reﬁll the water tank with fresh water and place it back on the

appliance. Empty the drip tray and clean it.

10. If you switch the appliance back on with the On/Off button, the descaling warn-

ing light has gone out. If the descaling warning light is still glowing,

please repeat the descaling process.

NOTE: Please wipe potential splashes of descaling solution on the appliance casing

away immediately, as the agent might damage the surface.

NOTE: If the descaling procedure is not completed correctly (e.g. no electricity), we

recommend to complete the procedure and rinse properly the appliance.

WARNING: Never submerge the power cord, the power plug, the grinder or

the appliance in water or any other liquid. During descaling, never remove

the water tank or allow it to empty completely.

■

STORING THE SOLIS GRIND & INFUSE COMPACT

ESPRESSO MACHINE

Store the cooled down, cleaned and dry machine in an upright position, ideally in

the original packaging. Do not place any items on the appliance.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Solis Grind and Iinfuse Compact 1018 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 24,64 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Solis Grind and Iinfuse Compact 1018 Manual

Product: