48
▲
ASSEMBLING RESP. DISASSEMBLING
THE APPLIANCE
ASSEMBLING THE APPLIANCE
1. Switch the appliance off with the ON/OFF button on the appliance back side
(position 0).
2. Push the lever press arm up, away from the motor base, until it reaches the high-
est position.
3. Place the juice collector over the drive shaft in the motor base. Ensure that the
juice spout is in the half-round opening at the front of the motor housing.
4. Now place the pulp filter in the juice collector. One of the arrows on the dark
grey bulge of the filter must line up with the arrow on the juice collector so that
both parts snugly fit into each other.
5. Place the juicing cone on the drive shaft and gently push the cone down so that
it is correctly placed on the drive shaft.
6. To install the squeezing cone into the lever press arm, push the tip of the
squeezing cone into the opening on the lower side of the lever. Thanks to the
magnet in the squeezing cone tip, it glides into the opening almost by itself and
is held there.
7. Now check if the juice spout is pointing downwards, meaning it is in pouring
position.
8. Switch the appliance on with the ON/OFF button (position I). It is now ready for
use.
DISASSEMBLING THE APPLIANCE
1. Switch the appliance off with the ON/OFF button on the appliance back side
(position 0). Then, pull the plug from the socket.
2. Push the lever press arm up, away from the motor base, until it reaches the high-
est position. Close the juice spout by folding it up into the no-drip position.
3. Remove the squeezing cone by carefully pulling it out of the lever press arm, over-
coming the magnetic drag.
4. Carefully lift the juice collector with the pulp filter and the juicing cone. Remove
the juicing cone and the pulp filter from the juice collector over a sink so that
the pulp leftovers can be easily removed. Then, clean the single parts as described
in the „Cleaning And Care“ section on page 51.