663504
29
Zoom out
Zoom in
Previous page
1/34
Next page
5756
Caution:
The jug is very hot during and after use! Therefore, never place the hot jug on a
heat sensitive surface!
Never place the hot jug on the power cord.
ADDING INGREDIENTS
If you want to add ingredients to the milk, the frothing process always has to be
running for a few seconds already. You can measure the solid or liquid ingredi-
ents off with the measuring cap and gradually pour them into the milk through
the lid opening. If you have set the temperature to a range between WARM and
HOT, you should wait for a while before adding the ingredients so that the milk
can warm up and the ingredients can dissolve more quickly.
Always add the ingredients to the jug slowly and in small amounts. If you add
the ingredients too quickly, the frothing disc could detach from the seating pin
or prematurely stop the frothing process.
The result of frothing depends on the added ingredients. If you add e.g. solid
ingredients like syrup, thick powder or large flakes, the froth will not be as creamy
and fluffy.
Notes:
The milk frother is not suitable for mixing dry ingredients like ground nuts, whole
spices or fresh herbs or for melting large pieces like chocolate cubes. The jug must
always be filled up to the MIN marking at least with liquid (milk).
The milk frother is designed for frothing and stirring milk, it can not whip cream,
prepare dessert sauces or stir soups, eggnog or sauces.
5. Place the jug back on the motor base, the outer bottom of the jug as well as the
opening in the bottom must be dry and clean.
6. Turn the START/STOP rotary knob to the desired temperature. If you want to froth
resp. stir milk for a cappuccino or a caffè latte, we recommend a temperature
setting in the OPTIMUM MILK TEMP range. Of course, different temperature
settings fitting personal tastes are also possible.
Should you change the temperature setting during use, the appliance heats the
jug contents to the newly set temperature.
7.
Push the START/STOP button inwards, the button surround flashes and the
frothing process starts.
Note:
Never remove the jug from the motor base while the appliance is in use. If you want
to stop the operation ahead of time, you can simply press the START/STOP button
again.
8. Once the milk has reached the set temperature, the appliance stops automati-
cally and a twofold signal is sounded. Heating up usually takes between 2 and
7 minutes, depending on the amount of milk and the temperature setting. Wait
for the built-in ventilator to stop and pull the power plug. Carefully take the jug
out of the motor base by the handle and keep in mind that the jug as well as the
milk can be very hot. Do not place the hot jug on a heat sensitive surface, e.g.
on plastic or on a tablecloth, as it might melt or be scorched.
9. Remove the lid and carefully pour the frothed milk into the cup.
10. Clean the jug with the lid and the measuring cap as well as the frothing discs
after every use. The jug with the frothing disc should be cooled down completely
before you disassemble it.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solis 868 - Cremissimo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solis 868 - Cremissimo in the language / languages: English, German, French as an attachment in your email.

The manual is 3,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info