663504

Solis 868 - Cremissimo Manual

28
Zoom out
Zoom in
Previous page
1/34
Next page
5554
BEFORE FIRST USE
Please remove all packaging materials and stickers resp. labels before first use. Rinse
the jug, the frothing discs, the lid and the measuring cap in warm dishwater with a
soft dishrag. Re-rinse under clear water and dry carefully. Wipe the motor base clean
with a slightly moist towel and dry it. Please refer to the section ”Cleaning and care”
on page 60 of this manual.
STARTING UP
FROTHING AND HEATING MILK
1. Place the appliance on a moisture resistant, even, clean and dry as well as heat
resistant work surface and connect the power plug to a suitable power outlet.
The button surround of the START/STOP button lights up to indicate that the
appliance is in standby mode.
2. Choose a suitable frothing disc:
Use the ”CAPP” frothing disc with teeth (I) for thick, creamy milk froth or the
“LATTE” frothing disc without teeth (J) for silkily stirred, only slightly frothed milk.
CAPP (I) LATTE (J)
3. Take the jug off the motor base and push the selected frothing disc onto the
seating pin in the milk jug. Push the frothing disc onto the seating pin with the
wider end first and press it down to lock it into place. Tip: The magnet makes the
frothing disc slide over the seating pin practically by itself, however, the frothing
disc still has to be pressed down until you hear a “click”, making sure that it is
firmly seated.
Note: Always make sure that the frothing disc is fully locked onto the seating pin,
only then you can fill in milk resp. liquid. Should the frothing disc not be firmly
seated, it might slide off of the seating pin and not froth resp. stir the milk.
Caution:
The frothing disc is small, therefore it could be swallowed by small children. This
makes it necessary that children are always supervised during use to prevent them
from taking the frothing disc. Danger of suffocation!
4. Pour the required amount of cold, fresh milk into the milk jug. Please note the
MIN and MAX marking on the inside of the jug, there should not be too little or
too much milk in the jug. Close the jug with the lid. The measuring cap should be
screwed shut in the lid. The rubber around the lid should air tightly seal the jug.
MIN MAX
Note:
To achieve optimal results, you should never exceed the MAX marking CAPP/LATTE
MAX (500 ml) on the inside of the jug!
Important:
Always use cold milk and pour at least so much milk into the jug that the MIN
marking is exceeded. The milk frother automatically switches off if the milk jug is
empty or the amount of milk lies below the MIN marking. Should this be the case,
you always have to wait a few minutes until the milk frother has cooled down before
using it again.
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solis 868 - Cremissimo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solis 868 - Cremissimo in the language / languages: English, German, French as an attachment in your email.

The manual is 3,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info