799500

Solac CE4520 Manual

10
Zoom out
Zoom in
Previous page
1/71
Next page
USE:
Connect the appliance to the mains.
Use the On/O󰀨 switch to switch the appliance on.
The indicator lights on the buttons will ash, indicating
that preheating is taking place.
When the preheating operation has nished, the lights
will remain lit. The buttons will not work during the pre-
heating operation.
The machine is now ready to make your co󰀨ee.
STANDBY MODE
Once the machine is switched on, it automatically goes
into Standby mode, awaiting a command.
In Standby mode the 1-co󰀨ee and 2-co󰀨ee lights stay
lit, and the thermoblock technology maintains the tem-
perature.
BREWING COFFEE
One co󰀨ee
Remove the lter holder, if it is already tted.
To enjoy the full aroma of the co󰀨ee, we recommend
emptying and cleaning the lter with a ne cleaning
brush after each use.
Fill the co󰀨ee lter with 7-8 g of ground co󰀨ee, and
press it down using the compactor on the measuring
spoon.
Place the lter in the lter holder and t the lter holder
in the machine, turning it anticlockwise to its locking
position.
NOTE: We recommend natural roast co󰀨ee. Torrefacto
co󰀨ee may a󰀨ect the operation of the machine.
Press the 1-co󰀨ee button. The machine will start PRE-
BREWING by pouring a little water over the co󰀨ee to
moisten it. It will then brew the co󰀨ee and stop automa-
tically, with three beeps to signal the end of the function.
Once the function has nished, proceed to clean the
lter.
Two co󰀨ees
Repeat all the previous steps, substituting the 1-co󰀨ee
lter for the 2-co󰀨ee one and lling it with approximately
15-16 g of co󰀨ee.
Press the 2-co󰀨ee button and the machine will operate
until brewing is completed.
Co󰀨ee capsule (Only on the Taste Slim ProCap model)
Open the capsule accessory lid by turning it anti-cloc-
kwise.
Place the capsule face up inside the space and close
the lid.
Put the accessory into the lter holder, positioning the
lid at the bottom of it.
Proceed to brew the co󰀨ee as normal.
To extract the capsule, remove the lter holder and
allow it to cool.
Take o󰀨 the lid and recycle the capsule as recommen-
ded by the capsule manufacturer.
Hot water
In Standby mode, open the steam/hot water control.
The pump will start to work and hot water will come out
through the steamer pipe.
Once nished, close the pipe using the steam control.
Steam / Frothing Milk
In Standby mode, press the steam button. This will start
to ash, indicating that the thermoblock is heating to a
temperature of 130 ºC to produce dry steam.
Insert the steamer pipe into the container holding the
milk or liquid to be heated.
Open the steam/hot water control. The pump will emit
small pulse sounds, generating steam.
Once the milk or liquid is hot, close the steam control
and wipe the pipe clean with a cloth.
When the function has nished, press the co󰀨ee button
to lower the temperature and switch back to Standby
mode.
COFFEE QUANTITY PROGRAMMING
With this co󰀨ee it is possible to set the amount of co󰀨ee
that each button brews. To do this, make a co󰀨ee by fo-
llowing the instructions above, changing only one step:
When pressing the button to brew the co󰀨ee, keep it
pressed down until you reach the desired quantity and
then release it.
The machine saves this setting for subsequent brews.
The time can be set from 20 to 75 seconds. (25 ml –
160 ml)
PROGRAMMING THE COFFEE MAKER
Programming menu
First, make sure that the co󰀨ee maker is in Standby
mode.
Next, press and hold the steam heating button for 5
seconds.
The lights on the buttons will ash consecutively. The
programming menu has now been accessed.
NOTE: If the machine remains inactive for 15 seconds,
it automatically switches back to standby mode.
Programming the temperature
Access the programming menu.
Press the 1-co󰀨ee button to enter the temperature set-
ting. Once pressed, the machine uses the lights to show
which level it was at:
1-co󰀨ee 2-co󰀨ees Steam Level
X Low
temperature
(70 ±5* ºC)
X X Medium
temperature
(75 ±5* ºC)
X X X High
temperature
(80 ±5* ºC)
* Temperature may vary depending on external condi-
tions.
EN
Downloaded by: pd-oliana on 12-08-2022 14:11 CEST
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Solac CE4520 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Solac CE4520 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 1.11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info