619690
9
Zoom out
Zoom in
Previous page
1/14
Next page
8
Installation S3
Once you have performed a download it is time to install the Snooper S3
into your vehicle. The most important aspects of this installation are
ensuring that the Snooper S3 is positioned in such a way that it has a
clear view of the sky whilst ensuring that the device is situated so that it
does not interfere with the vehicles controls and does not jeopardise
either the passengers or drivers safety.
For best results mount the S3 on to the vehicles dashboard so that the
top of the unit has a clear view of the sky. Some vehicles including
Renault’s, Citroens and Peugeot’s may come with a ’Heat reflective’ or
’Comfort’ front windscreen which may effect the performance of the
built-in GPS antenna, although the S3 will work effectively in vehicles with
a ’heated’ windscreen. In these situations you will need to purchase a
re-radiating antenna which can be positioned on the rear parcel shelf.
Contact Performance Products or your local dealer for further information.
In both cases the unit or extension antenna should be positioned so that
it has a clear view of the sky directly above. When positioning your
Snooper S3 ensure that it is located in such a way that you can easily
view the LED display without having to take your eyes from the road
ahead and so that you can reach the controls safely. Please also be
aware that you will need to be able to remove the device to perform
downloads. Once you have found a suitable location for your S3 secure it
in place with the ’Hook and loop’ fastener or suction cup bracket
provided, remembering to clean the area where the fastener or bracket is
going to be positioned thoroughly before hand to ensure a good contact.
More in depth mounting instructions are provided below.
PLEASE NOTE: Be careful to choose a location that does not block the
drivers view or where it might endanger the driver or passengers should
your vehicle suddenly come to a stop or be involved in an accident.
RS232
RD
Windscreen
Dashboard
19
Radar Alerts (Only applicable where S100 RLD is connected)
If you have the S100-RLD connected to your S3 you will be able to
receive radar alerts. The information provided is more basic than when
you receive an alert via GPS but still effective. When the device first
receives a radar alert the unit will begin to ’Beep’ slowly at first but
quicken as you get closer to the source. At the same time the LED
display will indicate that you are detecting radar by illuminating the letter
’R’ on the display. Next the red LED’s will illuminate starting with a single
LED and building up to 4 red LED’s as you get closer to the source of the
radar.
Laser Alerts
The S3 incorporates a built-in laser detector. As laser often requires
instant action the device simply gives you a loud audible alert whilst the
display will flash ’L’ and all 4 red LED’s simultaneously. No signal strength
will be indicated.
If you would like to Mute either a Radar or Laser alert, simply press the
’Mute’ button at any time during the alarm.
CANCEL
NEW LOCATION
MUTE
CANCEL
NEW LOCATION
MUTE
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Snooper S3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Snooper S3 in the language / languages: English as an attachment in your email.

The manual is 0,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info