361454
94
Zoom out
Zoom in
Previous page
1/108
Next page
94
7 - PETIT GUIDE DE DÉPANNAGE
F
7 - DEFEKTE UND LÖSUNGEN
D
7 - DIFETTI E RIMEDI
I
7 - TROUBLESHOOTING
GB
CAUSE
CURE
The machine either serves very little or no coffee at all.
a) The seal is damaged and this
causes a leak around the filter
holder.
b) Leak in the upper connection
of the filter holder.
a) Replace the lter holder gasket,
see paragraph 6.5 (to be car
-
ried out only by qualified per
-
sonnel or at authorised tech-
nical assistance centres).
b)
Check the seal of upper connec-
tion and tube (to be carried out
only by qualified personnel or at
authorised technical assistance
centres).
The display is switched off and the machine cannot be switched on.
a) There is no mains supply to the
machine.
b) One of the safety switches has
triggered.
c) There is a cut-out in the wiring.
d) The electronic board is faulty.
a) Check that the supply cable is
well connected to the machine
and to the mains plug. Check
that the mains switch is turned
on; in this case, check the feed
fuse: if it has burnt out, replace
it (see paragraph 1.1 ref.
6).
b)
Check that the upper cover
is closed correctly.
c) Contact an authorised technical
assistance centre.
d)
Contact an authorised technical
assistance centre.
CAUSA RIMEDIO
La macchina eroga poco caffè o non lo eroga affatto.
a) La guarnizione di tenuta è
danneggiata e questo causa
la perdita intorno al portafiltro.
b) Perdita nel raccordo superiore
del portafiltro.
a)
Sostituire la guarnizione por-
tafiltro, vedere paragrafo 6.5
(solo per personale qualificato
o presso centri di assistenza
autorizzati).
b) Controllare la tenuta del rac-
cordo superiore e del tubetto
(solo per personale qualificato
o presso centri di assistenza
autorizzati).
Il display è spento e non si riesce ad accendere la macchina.
a) Non arriva corrente alla mac-
china.
b) Una delle sicurezze è entrata
in funzione.
c) Il cablaggio è interrotto.
d) Le scheda elettronica è gua
-
sta.
a) Verificare che il cavo di ali
-
mentazione sia bene collegato
alla macchina e alla presa di
corrente, controllare che l’in
-
terruttore generale sia acceso;
in tal caso controllare il fusibile
alimentazione: se è bruciato,
sostituirlo (vedere paragrafo
1.1 rif.
6).
b) Verificare che il coperchio
superiore sia chiuso corretta
-
mente.
c) Rivolgersi ad un centro assi
-
stenza autorizzato
d) Rivolgersi ad un centro assi
-
stenza autorizzato
URSACHE LÖSUNG
Die Maschine produziert wenig oder gar keinen Kaffee.
a) Die Dichtung der Halterung
ist beschädigt und dies führt
zu Verlusten rund um den
Filterhalter.
b) Verluste in der oberen Lei-
tung des Filterhalters.
a) Ersetzen Sie die Filterhal-
terdichtung, siehe Paragraph 6.5
(nur für qualiziertes Personal
oder bei autorisierten Ser-
vicezentren).
b) Kontrollieren Sie die obere
Leitung und den Schlauch auf
Verluste (nur für qualiziertes
Personal oder bei autorisier-
ten Servicezentren).
Das Display ist ausgeschaltet und die Maschine kann nicht einge-
schaltet werden.
a) Die Stromzufuhr zur Maschine
ist unterbrochen.
b) Eine der Sicherheitsfunktionen
ist aktiviert worden.
c) Die Kabelverbindung ist unter
-
brochen.
d) Der elektronische Mikrochip ist
defekt.
a) Stellen Sie sicher, dass das
Stromkabel korrekt mit der
Maschine und der Steckdose
verbunden ist und überprüfen
Sie, ob der Hauptschalter
eingeschaltet ist. Überprüfen
Sie dann die Stromzufuhrsiche-
rung: falls diese durchgebrannt
ist, muss sie ersetzt werden
(siehe Paragraph 1.1, Ref.
6).
b) Überprüfen, dass der obere
Deckel korrekt geschlossen
ist.
c) Wenden Sie sich an ein autori-
siertes Servicezentrum.
d) Wenden Sie sich an ein autori-
siertes Servicezentrum.
CAUSE
SOLUTION
La machine extraie peu de café ou pas de café du tout.
a) Le joint n’est plus étanche et
provoque des fuites autour
du porte-filtre.
b) Perte dans le raccord supé-
rieur du porte-filtre.
a) Changez le joint torique du porte-
ltre, cf. paragraphe 5.5 (seule
-
ment par un personnel qualifié
ou auprès dun centre de service
aps-vente agréé).
b) Contrôlez l’étanchéi du rac-
cord surieur et du capillaire
(seulement par un personnel
qualié ou aups dun centre
de service après-vente agréé).
Le visuel est éteint et on arrive pas à allumer la machine.
a) Le courant n’arrive pas à la
machine.
b) Déclenchement d’un des
dispositifs de sécurité.
c) Le branchement a été inter-
rompu.
d) Défaut de la carte électro-
nique.
a) rifiez le branchement
du cordon d’alimentation
à la machine et à la prise
de courant, contrôlez si
l’interrupteur général est al-
lumé, dans ce cas contlez
le fusible dalimentation:
changez-le s’il est grillé (cf.
paragraphe 1.1 point
6).
b) Vérifier que le couvercle
supérieur est correctement
fermé.
c) Adressez-vous à un centre
de service après-vente
agréé.
d) Adressez-vous à un centre
de service après-vente
agréé.
94


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Smeg scm1-1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Smeg scm1-1 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Swedish, Spanish as an attachment in your email.

The manual is 3,27 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info