621496
107
Zoom out
Zoom in
Previous page
1/132
Next page
Installation
22081814H 105
The calibration should be done in calm sea conditions and with
minimal wind to obtain good results.
calibration?
RFC COMP
INSTALLATION
RFC COMP
calibrating
INSTALLATION
Calibration
INSTALLATION
confirmed
1. Begin turning the boat to starboard.
2. Start compass calibration by turning the course selector clockwise.
3. When the calibration is completed, (after having completed
approximately 1 1/4 turns), it will be confirmed in the display.
If the compass is close to disturbing magnetic objects, the compass
calibration may fail, and the display will show:
Calibration
INSTALLATION
failed
In that case move the compass to a better location and recalibrate.
After calibration, check the compass readout against a known
reference, other compass or leading line. If the reading is correct
(+/-3°) except for a fixed offset, use the COMPASS OFFSET setting to
input a fixed correction to offset the heading readout.
Press STBD [>] button to proceed to next menu item.
Compass Offset
The compass OFFSET feature allows you to correct for a constant
compass heading offset, that may be present as a result of the RFC35
being installed with a lubber line offset or a fixed offset remains after
the calibration procedure has been completed. The value of compass
offset is specific to the heading sensor that is selected at the time the
offset is entered. (For multiple heading sensor offset procedure, refer to
separate CI300X manual).
The following display is presented when accessing the COMPASS
OFFSET entry screen:
Heading : 194
Offset ?: 000
INSTALLATION
RFC
Dial in the correction by turning the course dial to offset the RFC35
heading to agree with the known, accurate heading. The offset value
can be either positive or negative.
Note ! The OFFSET required may be as great as 90 degrees, caused by the
orientation of the compass when installed. If an OFFSET still exists after
having accounted for the mechanical offset, one of the following problems
may still exist:
107


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad Robertson AP300X Marine Autopilot at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad Robertson AP300X Marine Autopilot in the language / languages: English as an attachment in your email.

The manual is 4,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info