621496
105
Zoom out
Zoom in
Previous page
1/132
Next page
Installation
22081814H 103
System unit Hardware port: Display readout:
All junction units NMEA Port #1 J300X-1
J300X, J300X-40 NMEA Port #2 J300X-2
All junction units Heading Sensor J300X
NI300X NMEA Port #1 NI300-1
NI300X NMEA Port #2 NI300-2
NI300X NMEA Port #3 NI300-3
NI300X NMEA Port #4 NI300-4
CI300X ANALOGUE (other
Fluxgate), MAGN.
COMP, GYRO
CI300X
RFC35R, RFC300 Robnet ROBNET
Output signal setup
Display readout Hardware Port Equipment connected
Output INSTR: J300X-1*
:–
J300X-1 Note
Output RADAR: Anritsu*
Furuno
RADAR
* default setting
Note ! The standard NMEA output rate is 1x/second. When Output INSTR is set
to J300X-1, the Junction Unit output port #1 (TX1) will have an output
rate of 5x/second for HDM or HDT messages (heading). The RSA (rudder
angle) message is always 5x/second.
3.13 Sea Trial
The Sea-trial menu can only be accessed if the Dockside Settings are
done and confirmed. It is also recommended that the Interface Setup
be performed prior to Seatrial settings.
The seatrial settings do the following:
Rudder zero adjust (To tell the AP300 the precise midships position
of the rudder)
Compass calibration (To automatically compensate for onboard
magnetic Deviation)
Compass Offset (To offset the final compass heading readout)
105


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad Robertson AP300X Marine Autopilot at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad Robertson AP300X Marine Autopilot in the language / languages: English as an attachment in your email.

The manual is 4,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info