621496

Simrad Robertson AP300X Marine Autopilot Manual

108
Zoom out
Zoom in
Previous page
1/132
Next page
Robertson AP300X Autopilot
106 22081814H
• The heading reference that you are comparing the RFC35 is not
accurate.
• The automatic calibration obtained by the RFC35 is not correct, and
may be due to a large magnetic influence near the RFC35. (A
relocation may be needed.)
Proceed to the AUTOTUNE function by pressing the STBD [>] button,
or return to STBY mode.
Automatic tuning
AUTOTUNE is a new dynamic function that enables the AP300X
system to automatically set up the steering parameters (Rudder,
Counter Rudder, Autotrim) for the boat. The scaling factors of the
parameters are also set automatically as a function of the boat type
selection performed in the Dockside Settings menu.
Note ! Autotune is an optional procedure that is not required for the AP300X to
function. The AP300X is preset with steering parameters that should steer
most boats in the 30 - 50 foot range and Autotune may not be required if the
preset parameters steer your boat acceptably.
Recommended speed during Autotune is 5-10 knots. Autotune should
not be performed at planing speed. It is recommended that the
Autotune be done in an East or West direction if possible, as these will
yield the best balanced parameters.
Caution ! The Autotune function will take control of the boat and perform a
number of S-turns. It must always be performed in open waters with
sufficient safe distance to other traffic. The Autotune function may
take from 1 to 2 minutes to complete.
tuning?
Automatic
INSTALLATION
tuning
Automatic
INSTALLATION
Autotuning
INSTALLATION
confirmed
Activate the AUTOTUNE, by rotating the course selector clockwise.
After the Autotune has been completed the rudder must be controlled
manually, as the mode is returned to STBY.
When the Autotune has been completed, there should normally be no
need for further adjustments. On certain installations, however, you
may want to "fine tune" the parameters after the Autotune due to the
special steering characteristic of a specific boat. Viewing or changing
the Autotune parameters are done from within the VIEW
PARAMETERS menu item.
Exit the Seatrial Settings menu by pushing STBD [>] button to proceed
to the View parameters menu, or press STBY to return to normal
AP300X operation.
… 108 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Simrad Robertson AP300X Marine Autopilot at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Simrad Robertson AP300X Marine Autopilot in the language / languages: English as an attachment in your email.

The manual is 4,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info