796202

Silvercrest SEM 1100 D3 - IAN 379540 Manual

17
Zoom out
Zoom in
Previous page
1/298
Next page
■ 14 │ GB│IE SEM 1100 D3
8) Slowly turn the steam control 7 in the direction “ “.
9) Move the frothing container around in a circular motion while keeping the tip
of the nozzle under the surface of the milk: deep enough that the milk does
not spray out, but shallow enough to create a thick froth. Done properly,
a deep buzzing sound is audible.
10) As the milk froth rises, push the nozzle deeper into the milk to froth up the
next “layer” and to avoid a burnt taste in the froth.
11) Finally, insert the nozzle completely and close the steam control 7 approxi-
mately halfway, so that the milk is heated. Hold the frothing container at a
slight angle, so that the milk gently swirls around while it is being stirred with
the nozzle.
12) Once the milk froth has reached the desired consistency and temperature,
turn the steam control 7 to off (up to the stop in the direction of the “ “).
13) Now you can remove the nozzle from the milk.
14) Proceed as described in the section “Cleaning the milk frother”.
NOTE
► For cappuccino, always use bigger cups than for espresso because frothed
milk will be added.
15) To prepare cappuccino, proceed exactly as you would for espresso (see
section “Preparing espresso”; preheating is no longer necessary). Allow the
water to flow through for about twice as long as an espresso (about 40 ml).
NOTE
► All of the control lamps may flash rapidly, if you press the “Espresso”
button 3 directly after preparing frothed milk. This means that the
appliance is too hot to prepare a perfect espresso. You can either continue
making an espresso anyway or allow the appliance to cool down.
As soon as the "Espresso" control lamp t lights up continuously, the
optimum temperature range for espresso has been reached again.
16) Switch the appliance off with the On/Off switch 1.
NOTE
► If the “Espresso” 3 or “Steam” 4 buttons are not pressed for
about 30 minutes, the appliance switches off automatically.
17) Now add the frothed milk into the previously prepared espresso. The cap-
puccino is now ready. You can add sugar or sprinkle it with cocoa powder
according to taste.
NOTE
► Always clean the milk frother 0 after every use. See also the section
"Cleaning and Care".
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Silvercrest SEM 1100 D3 - IAN 379540 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Silvercrest SEM 1100 D3 - IAN 379540 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 2.36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info